Home Protector 63795 User Manual - 3. Settings
18
2. Testing the PIR coverage area
a. In test mode the Security Light allows you to test the
coverage area.
b. After mounting and connecting your camera to AC power,
the camera will turn on automatically.
c. Slide the Camera switch to the TEST position, and the LCD
display will show TEST.
d. Whilst in test mode, each time the PIR sensor is triggered,
the RED test indicator on the front of camera will flash to
indicate a trigger. Walk around the coverage area to
determine if your camera is suitably mounted.
e. Adjust the position of your Security Light if necessary and
repeat the testing until you have achieved the desired
coverage area.
f.
When you have completed the coverage area testing, slide
the Camera switch to the CAM position and the Security
Light will start a 60-second countdown and the RED test
indicator will blink (one second on, one second off). Please
leave the coverage area within 60 seconds to avoid being
photographed or videoed.
3. Settings
You can change the settings on your Security Light. The default
values are shown below.
Please note after changing any settings, the test LED will blink
and the Security Light will count down for approx. 60 seconds
before arming.
Setting:
Default:
Time:
12:00
HH:MM
Date:
01:01:10
MM:DD:YY
AE frequency:
50 Hz
50/60
Image capture interval:
1 second
01-99
Resolution:
High
High/Low
Image capture method:
Video
Video/Photo
Floodlight control:
Auto
Auto
Video recording time:
10 seconds 10-60
Your Security Light can be used straight away but before use
you may wish to change some or all of the settings – please see
the next section.