Home-tek HT807 Instruction Manual - page 2
• To remove the dust cup container, hold the unit in
the upright position to prevent the dust from falling
out of the dust cup. (Fig. 6)
• To open the dust cup container, push the dust
cup release button and remove the dust cup
container by hinging away from the handle.(Fig. 7)
• Rotate the lower dust cup anti-clockwise to
separate it from the filter chamber. Empty and
clean the dust cup. (fig. 8 below)
Do NOT over tighten the dust cup when re-fitting.
• Pull the HEPA Filter to remove from the filter
chamber. A lug is provided in the centre of the filter
to ease removal (fig. 9)
• Separate the debris screen from the HEPA Filter
cartridge by grasping the debris screen with one
hand and the filter frame with the other and pull
apart. (fig. 10)
5
Operating Instructions
NOTE: The HEPA Filter must be used when operating the hand vacuum.
Using The Unit As A Hand Vacuum Cleaner
Insert the dusting brush/hose connector into the
brush chamber exhaust port and locate the flexible hose
into the hose clip at the rear. (see Fig 1)
Cleaning With the Hose
To use the hand vacuum with only the hose and the
dusting brush or crevice tool:
• Rotate the brush cover by pushing on the brush
cover release button until it clicks in place. (fig. 2)
• Remove the flexible hose from the brush chamber
exhaust port and take the hose out from the
hose clip. (fig. 3)
• To use the flexible hose with the dusting brush,
hold the hose in one hand and with the other,
pull out the dusting brush and turn the brush
anti-clockwise to lock the extended brush in place.
(fig. 4 below)
• To use the flexible hose with the crevice tool,
make sure that the brush is in the storage position
and insert the crevice tool into the opening of the
hose. (fig. 5)
CAUTION: The Hand Vacuum is a very powerful unit.
Make sure that you hold it firmly, otherwise it can slip
out of your hand and cause injury.
IMPORTANT: After each use always remove and clean
the HEPA Filter and debris screen. (see page 5 for
cleaning instructions)
WARNING: Failure to do this will reduce the suction power, may lead to the motor over-heating
and will invalidate your warranty.
4
Cleaning and Maintenance
Cleaning & Changing the HEPA Filter
WARNING: Always unplug the unit from electrical outlet before opening the dust cup container.
IMPORTANT: Do NOT use the HEPA Filter cartridge without the debris screen in place.
CAUTION: The suction hose must be free of any obstructions at all times. Otherwise, the motor
will overheat and could become damaged.
Important, Please Note: The HEPA Filter & debris screen will stop most of the tiniest dust
particles and airborne allergens from re-entering the air you breathe. In fact it stops 99.97% of all
particles as small as 0.3 microns- many times smaller than a human hair!!! Because of this
incredible filtration performance, the HEPA Filter will quickly accumulate dust inside the white
filter folds, many fine dust particles that are difficult to see but which will eventually block or
reduce your suction power if not properly maintained. Clean the HEPA Filter and debris screen
after each use as described in this section.
Brush cover
rotates downwards
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6
Figure 7
Figure 8
Figure 9
Figure 10
HT807 HUNTER Ins (a) 2/20/07 12:12 PM Page 3