HoMedics MCS-490H Instruction Manual And Warranty - page 5
8
9
Full Back Cushion with
Custom Fit Massage
with Heat
NOTE: The moving
massage mechanism
always “parks”
or finishes in its
lowest position. It
will continue to this
position after the
power has been
turned off. If the
electrical supply is
interrupted, when
power is restored,
the mechanism will
“park” or move to
its lowest position.
demo Button
For a brief demonstration of the features of the Massage cushion, press
the Demo button. The unit will briefly go through each function. Once
completed, the unit automatically turns off. The L.E.D. light will blink to
indicate active function.
perfect Fit
To customize the massage to your height, press the PERFECT FIT
button at the highest desired position while the massage function is
on. The massage heads will not travel higher than the selected position
for the duration of the massage. To deselect, press the PERFECT FIT
button a second time.
rolling massage
Rolling is like two hands working slowly up and down your back.
Width adjustment
While the unit is in Rolling massage, press this button to adjust the
distance or width between the massage heads. With each press, the
massage heads will move to the next available position.
Heat Button
For soothing heat, when massage is on, simply press the heat button
and the corresponding red L.E.D. light will illuminate. To deselect,
press the button again and the corresponding L.E.D. light will turn off.
For your safety, heat cannot be turned on if no massage program is
selected.
NOTE: There is a 15-minute auto shut off
on the unit for your safety.
power Button
To turn on the massage functions,
first press the POWER button. The
L.E.D. indicator will illuminate and confirm
your selection. To turn off the massage
functions, simply press the button again.
The L.E.D. indicator will blink while the
massage mechanism returns to its lowest
point and then it will turn off.
Kneading massage
Kneading is a deep massage.
massage Zones
Choose from 3 preset zones in
Rolling or Kneading where the
massage travels up and down in
a specific area of the back, full,
upper or lower. To select a program,
simply press the button and the
L.E.D. will illuminate. To deselect,
press the button again or press
another button.
spot massage
While the unit is in Kneading
massage, press either button to stop
and focus the Shiatsu action in one
place. Once the unit is operating
in Spot Massage, you may adjust
the mechanism position by holding
down either button until the desired
position is reached. The Up Arrow
will move the mechanism upwards
and the Down Arrow will move it
down. Once you release the button,
the mechanism will stop in that
place.
NOTE: When
“POWER” button
is pressed for
first-time use, the
moving mechanism
will automatically
move to the lowest
position before
starting a massage
program. After initial
use, mechanism
will always park at
lowest position. See
note below regarding
parking.