I.E.M. klock Instruction Manual - page 10
4.1 Start Of Operation
Open the battery compartment on the back
side of the device. Insert the batteries as shown
below. Check that the polarity is correct - see
label - and that the strip is under the batteries.
Always use high quality 1.5 V batteries.
Now you should set time and date (see Setting
Time And Date).
“Klock” is now ready for use.
4 Use Of The Device
4.2 How To Apply The “Klock” To Your Wrist
The blood pressure measurement device is
put on like a normal wrist watch. Fix the cuff
on your wrist. In order to get correct measure-
ment results and to avoid unneccessary error
measurements, arm, hand and fingers should
be held still during measurement, and you
should not talk. You should be seated. Always
hold the device at the level of the heart.
8
5
4 Use Of The Device
4.9 Description of Symbols
SYS [mm ⁄ Hg]
DIA [mm ⁄ Hg]
PULSE [
1
⁄
min
]
HOUR
MIN
DAY
MON
Err 01
No
Clr
Co
Operation / Situation
Pulse detected
Display systolic value
Display diastolic value
Display pulse
Time of event
Display of hour
Display of minute
Display of day
Display of month
displayed when battery is empty
Error message
Number of measurement
Delete stored measurements
Infrared communication mode
Meaning
upper value
lower value
number of pulses / minute
sound / blinking as a reminder
change batteries (see 4.1)
see 6.1
if the left button is pushed 5 more
seconds, all stored data will be deleted
Bidirectional or data download option
and reminder function programming