I-Flash P13DIR User Manual - page 22
i-Flash Technology Limited
Rm 1110, 11F, Fabrico Industrial
Buildings, 78 Kwai Cheung Road,
Kwai Chung, NT. Hong Kong
Web:
Tel:
Fax:
Email:
www.iflashtec.com
+852 2110 9587
+852 3585 5233
info@iflashtec.com
PULSE DIR Series Installation Guide
22 |
P a g e
Register DIR to a SIP Server
1. From the DIR home page, click Basic Settings > SIP.
2. Go to SIP Settings Tab.
3. General Phone Settings.
Registered – The field shows the registration status of the account with the SIP server.
Unregister On Reboot – If it’s checked, the SIP user’s registration information will be cleared
from the server when the phone reboots.
4. Enter the required information.
Account Name
– The field configures the SIP account name.
SIP Server
– The SIP Server’s IP address or Domain name provided by your service
provider.
Outbound Proxy
– The IP address or Domain name of the Outbound Proxy, Media Gateway,
or Session Border Controller. Used for firewall or NAT penetration in
different network environments. If the system detects a symmetric NAT,
STUN will not work. ONLY outbound proxies can provide a solution for a
symmetric NAT.
SIP User ID
– User account information provided by your service provider (ITSP); this is
either an actual phone number or is formatted like one.
Authenticate ID
– The SIP service subscriber’s Authenticate ID used for authentication. It
can be identical to or different from the SIP User ID.
Authenticate Password
– The SIP service subscriber’s account password for the GXV to register to
the SIP server of the ITSP.
STUN Server
– If the device is behind a router, a STUN server is needed to help
penetrate the NAT.
Stream
– To choose between Primary and Secondary stream.
Preferred Vocoder
– To choose different Vocoder type.
Registration Expiration
– This parameter allows users to specify the time frequency (in minutes) in
which the GXV refreshes its registration with the specified registrar. The
default interval is 60 minutes.
Local SIP Port
– This parameter defines the local SIP port used to listen and transmit. The
default value is 5060. Local RTP Port – This parameter defines the local
RTP-RTCP port pair that is used to listen and transmit. The default value is
5004.
5. Click Save to save all the changes. You need to restart the device to apply all changes.