I-SENS CARESENS DUAL Owner's Booklet - page 28
52 www.i-sens.com
www.i-sens.com 53
Step 1
Without inserting a test strip, press the ◀
and
S
buttons simultaneously for 3 seconds
to enter the time alarm mode. ‘alarm1’
will be displayed while ‘OFF’ blinks on the
screen.
Step 2
On pressing the ▶ button, ‘alarm1’ is set and
‘On’ is displayed on the screen. Press the ▶
button again to cancel ‘alarm1’. ‘OFF’ will
blink on the screen.
Step 3
Press the ◀ button while 'On' blinks to
adjust the time of ‘alarm1’. A number
indicating the hour will blink on the screen.
Press the ▶ button to set the hour.
Setting the Time Alarms (alarm 1–3)
Setting the Alarm Function
Step 1
Turning the PP2 alarm On
Without inserting a test strip,
press and hold the ◀ button for
3 seconds to set the post-meal
alarm.
'PP2’ , bell ( ) symbol and ‘On’
will be displayed. The screen will
then automatically change to
the memory recall mode. At this
time, bell ( ) symbol, indicating
that the PP2 alarm has been set, will be displayed on the screen.
Step 2
Turning the PP2 alarm OFF
To turn off the PP2 alarm, press
and hold the ◀ button for 3
seconds. ‘PP2’ , bell ( ) symbol
and ‘OFF’ will appear on the
screen. Then the screen will
change automatically to the
memory recall mode without
bell ( ) symbol displayed.
Four types of alarms can be set in the CareSens Dual Meter: one
post-meal alarm (PP2 alarm) and three time set alarms (alarm1–
3). The PP2 alarm goes off 2 hours after setting the alarm. The
alarms ring for 15 seconds and can be silenced by pressing any
button or by inserting a test strip.
Setting the Post-meal Alarm (PP2 alarm)
' ' disappears
Note:
The PP2 alarm will automatically turn off if the meter's time
setting is adjusted to more than two hours before or just past
the currently activated PP2 alarm time.