I-Stor iS607 User Manual - Chapter 2 - System Setup

   i-Stor LAN                                                                                                    User Guide 

Chapter 2 - System Setup  /  Page 4 

Chapter 2 - System Setup 

HDD Installation 

Your unit may come with a pre-installed hard drive. Before opening such an enclosure, 

please read the warranty and any other notes from your vendor carefully before doing so, 

as this could void your warranty. 

1. Remove the four screws from the 

bottom of the case. 

2. Push the inner enclosure out, and 

remove the outer chassis. 

3. Install the first hard drive by placing it 

in the enclosure and connecting the SATA 

plus power cables. 

4. Mount the drive with two screws on 

each side. 

5. Attach the thermal probe with the tape 

provided to the first hard drive.  

Choose a location in between the two 

drives but without damaging the thermal 

probe when installing the second drive. 

6. Install the second hard drive by placing 

it in the enclosure and connecting the 

SATA plus power cables.