1. DL manuals
  2. I-Tech
  3. Headphone
  4. i.Oval 303
  5. User Manual

I-Tech i.Oval 303 User Manual

Summary of i.Oval 303

  • Page 1

    3 4 5 5-8 8-9 9-11 12 13-14 15-16 17-20 20 product specifications i.Oval 303 overview getting started charging your headset pairing your headset with a bluetooth mobile phone using your headset factory reset troubleshooting safety information care and maintenance declaration of conformity contents b...

  • Page 2

    Getting started to use your i.Oval 303 bluetooth headset (“headset”), please follow the steps below: 1. Ensure your headset is fully charged. 2. Pair your charged headset with a bluetooth-enabled mobile phone. Charging your headset the headset comes with a built-in rechargeable battery. Prior to usi...

  • Page 3

    Pairing your headset with a bluetooth mobile phone if the pairing cannot be completed within three minutes after the pairing mode has been activated, the headset’s status indicator will stay green three seconds and then turns to standby mode. Repeat steps 1 to 3 to pair the devices again. When you t...

  • Page 4

    Troubleshooting i can hear crackling noise. To receive the best audio quality, it is recommended to wear your headset on the same side of the body as your mobile phone. I can't hear anything in my headset. • ensure the headset is turned on and is properly charged. • ensure the headset is properly pa...

  • Page 5

    • do not expose the headset to extremely high or low temperatures. • do not leave the headset in direct sunlight for an extended period of time. • do not leave the headset near open flames such as cooking burners. • do not dispose of the headset in a fire, as it will result in explosion. • do not br...

  • Page 6

    Dispose of the packaging and this product in accordance with the latest provisions. 2009 hutchison harbour ring enterprises limited all rights in this publication are reserved and no part may be reproduced without the prior written permission of the publisher. The contents of this publication are be...