Summary of M7
Page 1
I.Trek m7 bluetooth gps receiver user’s manual published on jan. 3 rd , 2008.
Page 2
1 table of contents chapter 1 before you begin .................................................. 3 1.1 appearance .............................................................. 4 1.2 checking the package content .................................. 5 chapter 2 getting started............................
Page 3
2 note and warning - i.Trek m7 uses lithium battery. If i.Trek m7 is used in temperature lower than -10 ℃ or higher than 60 ℃ , its battery charging capability will decrease. Please leave the i.Trek m7 far from heat or high temperature environment. In addition, do not expose your i.Trek m7 in temper...
Page 4
3 chapter 1 before you begin thank you for purchasing the bluetooth gps receiver, i.Trek m7, a global positioning system receiver with bluetooth wireless technology. I.Trek m7 is well suited to system integrations including pda, smart phone, tablet pc and notebook pc with bluetooth devices. It can s...
Page 5
4 1.1 appearance 1. Power jack (mini usb type) 2. Mode switch (power off/ navigation (bluetooth)/ usb) 3. Battery status led (red/green) 4. Bluetooth status led (blue) 5. Gps status led (orange) 6. Internal antenna.
Page 6
5 1.2 checking the package content congratulations on your purchase of the i.Trek m7 with built-in lithium rechargeable battery. Before you start using i.Trek m7, please make sure if your package includes the following items. If any item is damaged or missing, please contact your dealer at once. - b...
Page 7
6 chapter 2 getting started please follow the procedure step by step. Step 1 charging your battery for the 1 st time you use the i.Trek m7, please charge battery until it is full (the led blinks). Take the power cable and connect it to the power jack (mini usb type). This will begin to charge the ba...
Page 8
7 step 2 turn on the power switch nav (bluetooth)/ usb/off power off navigation (bluetooth) usb step 3 connecting your handheld device with i.Trek m7 please refer to the user manual of pda to enable the bluetooth connectivity. If the connection between your device and i.Trek m7 is successful, the bl...
Page 9
8 --> start -> bluetooth manager new 1. Open “bluetooth manager” on pocket pc, and establish new connection. --> explore a bluetooth device ->next tap ibt-gps.
Page 10
9 2. Explore a bluetooth device, and find the “ibt-gps” passkey 0000 (if your pda ask for the passkey) 3. (optional) --> select spp slave->next finish.
Page 11
10 4. Connect to serial port profile (spp) slave --> tap and hold ibt-gps: spp slave, connect done 5. Finish bluetooth manager setup step 4 load your gps mapping or routing software step 5 start the application select the correct com port & baud rate. Note: the bluetooth device in most of the applic...
Page 12
11 chapter 3 how to configure your gps receiver ? The gpsview program only supports the microsoft windows based platform. 3.1 usb driver installation before the usb connector plugs in your pc/ laptop, please have your usb driver installation ready. (install cp210x driver for usb port from cd-rom.) 3...
Page 13
12 still more options for choice of nmea output, dgps…etc. All available through pull-down menus..
Page 14
13 appendix a. Led display the bluetooth gps receiver has three led lights, one is bluetooth status led, the 2 nd one is battery status led, the 3 rd one is gps status led. The status table of led shows as follows: category symbo l color status function always on: not connected to any bluetooth devi...
Page 15
14 appendix b. Fuzzy auto on/off i.Trek m7 supports fuzzy auto on/off. It can automatically enter the sleeping mode after your turning off the bluetooth connectivity, thus you can always power it on with very low power consumption. With fuzzy auto on/off, if the connection between your device and i....
Page 16
15 acceleration without aid: dgps (waas,egnos,msas): timing accuracy 50 ns rms reacquisition time hot start 1s warm start 33s cold start 36s sensitivity acquisition:-144dbm tracking:-158dbm update 1~5hz dynamic altitude maximum 18,000m velocity maximum 515m/s acceleration maximum 4g power input volt...
Page 17
16 operating temperature -10 ~ 60c storage temperature -20 ~ 60c charging 0 ~ 45c bluetooth standard fully compliant with bluetooth v1.2 output power 0dbm (typical),classii range 10 ~ 15 meters bluetooth profile serial port profile(spp) frequency 2.4g ~ 2.4835ghz ism band security yes physical chara...
Page 18
17 appendix d. Frequently asked questions q: the gps demo software gpsview doesn’t seem to be making any connections with my bluetooth gps receiver. How do i make it work? A: you will need to make sure your pda is paired with bluetooth device. Follow the section “chapter 2. Getting started > step 3 ...
Page 19
18 appendix e. How to change battery step 1 press the button to right side step 4 fit new battery into i.Trek m7 step 2 open the cover of battery step 5 from r to l close the cover step 3 take out the battery step 6 done.
Page 20
19 appendix f. Helpful tips your i.Trek m7 should be treated with care and properly maintained to ensure the best performance. Keep in mind these helpful tips when using your receiver: - some vehicles having heavy metallic sun protecting coating on windshields, which may affect signal receptions - d...
Page 21
20 appendix g. Certification fcc notices this device complies with part 15 of the fcc rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interface, and 2. This device must accept any interference received, including interference that may cause undesired...
Page 22
21 ce notices is herewith confirmed to comply with the requirements set out in the council directive on the approximation of the laws of the member states relating to electromagnetic compatibility (89/336/eec), low-voltage directive (73/23/eec) and the amendment directive (93/68/eec), the procedures...
Page 23
22 appendix h. Warranty and support information thank you for your purchase of gps product from the company. The company warrants this product to be free from defects in materials and workmanship for one year from the date of purchase. The warranty for accessories is six months. The stamp of distrib...
Page 24
23 warranty model number: series number: data of purchase: name: address: city, zip code: state, country: e-mail address: distributor stamp here.