I3 International Annexxus 36-series Quick Start Manual - Power Supply

Manual is about: Megapixel 360º Cameras

Summary of Annexxus 36-series

  • Page 1

    Ax36-series megapixel 360º cameras quick start guide contents warnings and operation notes .................................................. 1. .3 installation ............................................................................ 2. .5 initial network settings ..................................

  • Page 2

    2 i3-trng-cams-ax36d.Indd rev. 120402 annexxus 36-series camera quick start guide copyright © 2012 by i³ international, inc. All rights reserved. No part of this manual may be reproduced or transmitted in any form or by any means, electronic or mechanical, including but not limited to, photocopying,...

  • Page 3: Precautions

    3 i3-trng-cams-ax36d.Indd rev. 120402 1. Warnings and operation notes thank you for purchasing i³ annexxus 36-series camera. If the system needs to be modified or repaired, contact a certified i³ international dealer/installer. When serviced by unauthorized technician, the system warranty will be vo...

  • Page 4: Power Supply

    4 i3-trng-cams-ax36d.Indd rev. 120402 power supply ensure the supplied voltage meets the power consumption requirements of this camera before powering the camera on. Incorrect voltage may cause irreparable damage to the video camera and will effectively void the camera warranty. Cleaning for maximum...

  • Page 5: 2.  Installation

    5 i3-trng-cams-ax36d.Indd rev. 120402 2. Installation starting up working [flashes on/off] option 1 power over ethernet option 2 local power supply poe device class2 psu 12v dc 5w.

  • Page 6: Initial Network Settings

    6 i3-trng-cams-ax36d.Indd rev. 120402 3. Initial network settings network camera default settings dhcp if supported by network, otherwise: ip address: 192.168.1.100 netmask: 255.255.255.0 gateway: 192.168.1.1 pc / laptop settings ip address: 192.168.1.Xxx netmask: 255.255.255.0 gateway: 192.168.1.1.

  • Page 7: Accessing The Camera

    7 i3-trng-cams-ax36d.Indd rev. 120402 4. Accessing the camera from the disk that came with your camera, run the install.Exe file to install ax36 camera utility. You may be asked to restart your system after installation. Once the camera utility has been installed: double-click the 1. 360 camera util...

  • Page 8: Changing Ip Settings

    8 i3-trng-cams-ax36d.Indd rev. 120402 5. Changing ip settings after completing steps above, repeat instructions in the ‘accessing the camera’ section on page 7 using the new ip address. Or type in ip address into your pc / laptop web browser. Step 1 step 2 step 3 step 4 step 5 step 6.

  • Page 9: Changing Camera View

    9 i3-trng-cams-ax36d.Indd rev. 120402 6. Changing camera view pan / tilt / zoom controls (ptz) or click the image to pan or tilt and use mouse scroll wheel to zoom (except ie) view select.

  • Page 10: Optimizing Image Quality

    10 i3-trng-cams-ax36d.Indd rev. 120402 7. Optimizing image quality per-view adjustments camera adjustments.

  • Page 11: Factory Default

    11 i3-trng-cams-ax36d.Indd rev. 120402 8. Factory default remove camera from installed location (leave powered on) 1. Remove screw entirely (highlighted below) 2. Insert pin/paperclip and hold for approximately 10 seconds (led will turn off) 3. Camera will then reboot (this will take approximately 2...

  • Page 12: Specifications

    12 i3-trng-cams-ax36d.Indd rev. 120402 9. Specifications camera image sensor ½. 5 ” cmos 5mp lens f2.0 185º fisheye responsiveness 1.4 v/lux-sec max resolution 2144x1944 preset positions 10 privacy zones 10 video compression mjpeg, mpeg-4, h.264 frame-rate 12.5 fps at max. Resolution streaming multi...

  • Page 13: Notes:

    13 i3-trng-cams-ax36d.Indd rev. 120402 notes:.

  • Page 14

    I³ international inc. 1.866.840.0004 www.I3international.Com canada 780 birchmount road, unit 16, scarborough, on, m1k 5h4 u.S.A. 1967 wehrle drive, suite 1, pmb# 034 buffalo ny, 14221.