IAdea XMP-320 Quick Start Manual

Page of 4

Download

Bookmark us

XMP-320/330 Media Player

This printed quick guide provides a quick walkthrough of the set up process.

For complete documentation, please visit www.digisignage.com

Box Contents

Mounting and Installation

The player can be attached to mounting posts on

the back of screens or inside cabinetry with the

built in VESA MIS-D100 (100mmx100mm)

compatible mounting flange

(For XMP-330 only)

ATTACH the wireless

antenna as shown.

Screw antenna

clockwise onto the post

Media Player Unit

AC Power Adapter

12V DC output

Standard 3.5 mm to

RCA AV Cable

Ethernet Cable

Quick Start Guide

Wi-Fi Antenna

(XMP-330 only)

Quick Start Guide

(this guide)

A USB keyboard is required to change system settings.

USB Keyboard required

CF card cover/remover

(pre-installed on unit)

Page 1
Xmp-320/330 media player this printed quick guide provides a quick walkthrough of the set up process. For complete documentation, please visit www.Digisignage.Com box contents mounting and installation the player can be attached to mounting posts on the back of screens or inside cabinetry with the b...
Page 2
Iad-dgs-x32-10ep revision 1.1 port connections system setup 1 attach a video cable (either vga or hdmi) to your monitor. → when using vga, your monitor must support xga (1024x768) resolution or greater. Connect audio using the included av cable. → when using hdmi, audio and video are sent over a sin...
Page 3
4 wait while player boots up (up to 60 seconds) → once you see “welcome” on screen, the unit is ready for content update or menu configuration 5 plug in a usb keyboard to the unit’s usb port → the player will enter the graphical menu system in approx. 30 sec. 6 navigate the menususing your keyboard ...
Page 4
Iad-dgs-x32-10ep revision 1.1 content management please consult the software documentation for information specific to your management solution. Troubleshooting why is there no video output on composite video connectors? The player outputs video over hdmi and vga by default. To switch to composite v...