IAG IOC9SG3 Installation And Operation Manual - page 24
24
461306345 (A-001)
CHANGING THE FLEXIBLE GAS HOSE
In order to guarantee that the gas hose is always in
excellent condition we strongly recommend changing
it on the date you will fi nd printed on it.
REPLACING THE ELECTRICAL COMPONENTS
• The rear protection will have to be removed in order
to change the electrical heating elements, terminal
board and power cable.
• If you have to change the power cable (see the
cross section on table on page 25), always keep
the earth wire longer than the phase wires and,
in addition, follow all the instructions given in
the “ELECTRICAL CONNECTION” paragraph.
• To change the oven lamp see the instructions on
page 14.
• To change the lamp holder, the spark generator and
the spark electrodes, the work top has to be removed
as indicated in the paragraph «REPLACING THE
TAPS AND THERMOSTAT».
• To change the lamp-holder (fi g. 13), unscrew the
protective glass cap (C), force the tabs of blockage
and take the lamp-holder toward the inside of the
oven.
• To change the eventual programming accessory,
the swtch and the warning lights, remove the front
panel as indicated in the paragraph «REPLACING
THE TAPS AND THERMOSTAT».
6. INSTRUCTIONS FOR THE INSTALLER