This manual assumes that the door has been prepared for a us standard deadbolt lock. If the door has not been prepared, please refer to the documentation that came with the door cutting hardware. Preparing a standard us preparation for lock installation with the bolt extended (a), locate the stamped...
Measure the thickness of the door. The biobolt often requires the tailpiece that turns the deadbolt be the trimmed to the appropriate length for the thickness of the door. Adjusting the tailpiece for the proper door thickness identify the amount of the tailpiece that will need to be trimmed based on...
Place the rubber gaskets (a) on the rear potions of the front and back lock bodies. A small lip should surround the lock bodies. The potion of the gasket that makes contact with the door should be smooth and flat. Installing the biobolt on a us standard preparation door with the gasket attached, pla...
