IBeam ISD710 Quick Start Manual - page 2
Maritime Antenna Installation Guide
Step One:
Antenna Cables to be brought
to top of pole or mast
Connects to IsatDock
Step Two:
Place pole or mast mounting
bracket over the top of the
pole or mast and fix with 3
grub screws.
Connects to IsatDock
Antenna Coverage
Step Three:
Attach both SMA connectors
to the bottom of the antenna
making sure to connect
the GPS cable to the GPS
connector and the Inmarsat
Cable to the ISAT connector.
Connects to IsatDock
Step Four:
Place the antenna on top of the
mast or pole and screw in the
3 mounting screws (with a split
washer and a flat washer on
each) to hold it into place.
Connects to IsatDock
Installation Guidelines
To ensure maximum performance of the antenna system and to
maximise availability and reliability of service the antenna must;
•
have a clear line of site to the sky
•
be clear and free of obstructions
•
be clear of metal objects
•
be located away from other transmitting devices
•
be securely affixed in location
•
not be located indoors
•
be installed in conjunction with a certified cable
Installing Antenna Cables
When installing antenna cables, follow these guidelines:
•
Route and restrain cables to prevent them from vibrating
or moving under normal conditions, which could result in
damage to the antenna or the coaxial cable connections.
•
Wherever the cables contact structures, protect the
cables from chafing or abrasion. If a cable needs to be
bent, avoid kinking it, and ensure that each bend radius
follows the cable supplier limits.
•
Use coaxial sealant, shrink‐wrap tubing, electrical tape,
or another suitable product to seal all cable connections
appropriately to prevent moisture and corrosion damage
from weather exposure.
•
Mount all antennas vertically and clear of nearby metal
obstructions.
•
Minimize horizontal obstructions as much as possible
because they can create areas of poor system coverage.
Installation Options
The antenna system is suitable for marine, vehicle and
fixed applications and is designed to meet Inmarsat System
performance requirements when installed according to the
instructions in this guide.
The following figure shows typical Installations:
The antenna must be installed without obstruction of other
instruments or structures. The antenna must not be positioned
within range of radar equipment or other RF interference.
Maritime Antenna Kit Contents
1.
Maritime Antenna
2.
Pole or Mast Mounting Bracket
to suite 34mm diameter pole
3.
3 x Small Mast Mounting Grub Screws
4.
3 x Large Antenna Mounting Screws
5.
3 x Small Split Washers
6.
3 x Large Flat Washers
2
1
3
4
5
6
I-4 Americas
I-4 EMEA
I-4 Asia-Pacific
WARNING
To satisfy FCC RF exposure requirements for mobile transmitting devices, a separation distance of 55 cm or
more should be maintained between the antenna of this device and persons during device operation. To
ensure compliance, operations at closer than this distance is not recommended.
Sourced from Inmarsat
NOTE:For Satellite & GPS connection instructions please consult your Beam Inmarsat Product manual.
WARNING: Do not place the antenna anywhere there is a source of heat or fumes such as the ship’s exhaust.