Ibiza Pro LAS5000RGB User Manual - page 3
©Copyright Lotronic 2011 LAS5000RGB
www.ibizalight.com
Page 3
1-255
Small to big
Channel 11
Spot and line
0-255
Line to spot
Channel 12
Twinkle speed
0-22
Slow to speedy
PC Control
If it is set to ILDA mode (use PC software to control light), you just need to connect
the ILDA signal to the DB25 jack. ILDA mode (PC control) and built-in program
mode can be identified and transformed automatically.
Troubleshooting
1. If the power supply indicator doesn't light up and the laser doesn't work, please
check the power supply and the input voltage.
2. In Stand-Alone operation, if the power supply indicator is light up and sound
active indicator isn't light up, but the laser is shut off doesn't work.
A. Because sound is too small make for laser shut off in sound active, please
increase the music volume or increase audio sensitivity with sensitivity knob,
please check as below.
B. Please check if unit has been set up in slave mode, then set up in master mode.
3. In Master-Slave operation, slave unit don't function, please check as below.
A. Make sure to there's only one master in the chain, and the others are set in
slave mode.
B.Make sure to take a good quality power cable and connection.
4. In DMX mode operation, the laser is OFF and the DMX signal indicator is
unlighted, please check as below.
A. Make sure to set up the DMX mode.
B. Make sure to have a good connection.
5. In DMX operation, the unit can’t be controlled by the DMX console, but the DMX
signal indicator is flashing, please make sure the DMX console and unit have the
same channel.
6. If the output beam direction above isn't the right way, please restart the unit.
7. If the unit is fail, please turn off the unit, then turn on again after 5 minutes.
8. In PC mode operation, the laser is OFF after the swimming fish, please check
as below
A. Please press the button of animation
B. Make sure the SD card is insert with good connection
After trying the above solution you still have a problem, please contact your dealer
or our company for service.
Electric products must not be put into household waste. Please bring them to a
recycling centre. Ask your local authorities or your dealer about the way to
proceed.
F - MANUEL D’UTILISATION
Lire attentivement le manuel avant la première mise en service et le
conserver pour référence ultérieur. Cet appareil a quitté l’usine en parfait état
après avoir passé une série de contrôles de qualité très stricts.
Vérifiez le contenu à l’ouverture de l’emballage
L’emballage doit contenir les pièces suivantes :
1 Effet laser IBIZA LIGHT LAS5000RGB
Touche d’urgence sur la télécommande
1 cordon d’alimentation
1 manuel d’utilisation
CARACTERISTIQUES TECHNIQUES
1. Alimentation: 110/240V, 50/60Hz, Fusible : 3A/250V
2. Consommation : 200W
3. Diode laser: DPSS, vert 532nm 1000mW, rouge 650nm 2000mW,
bleu 450nm 2000mW
4. Puissance du laser : 5000mW
5. Moteur : Scanner haute vitesse 30 kpps
6. Modes de fonctionnement: Activation audio, automatique, DMX, ILDA
7. Canaux DMX : 12
8. Dimensions : 625mm x 480mm x 250mm
9. Poids net : 34kg
10. Poids brut : 38kg
DANGER
RAYONNEMENT LASER !
EXPOSITION AU FAISCEAU DANGEREUSE
APPAREIL À LASER DE CLASSE 3B
AVERTISSEMENTS
o
Ne pas exposer l’œil humain au rayon laser.
o
Ne mettre fréquemment l’appareil sous et hors tension.
o
Cet appareil doit être relié à la masse.
o
Uniquement pour utilisation à l’intérieur. Tenir à l’abri de l’eau, de l’humidité et
de secousses. La température de fonctionnement est de 18-30°C. Ne pas
utiliser l’appareil plus de 4 jour en continue sous peine de diminuer sa durée
de vie.
o
Nettoyez régulièrement la lentille extérieure avec un chiffon propre pour retirer
la poussière accumulée et optimiser la puissance lumineuse.
o
Ne pas retirer l’étiquette de garantie sous peine d’invalider la garantie.