Ibiza Sound XTK12A User Manual - page 2
-
Position the stand so that the legs do not present a trip hazard.
-
Do not attempt to place more than one speaker on a stand.
Disconnection from the mains
a) Where the MAINS plug or an appliance couples is used as the
disconnect device, the disconnect device shall remain readily
accessible.
b) If a switch is used to disconnect the device, the switch and its function
must be clearly identified and remain easily accessible.
Fuse replacement
Disconnect the power cord before replacing a fuse. Always replace with the
same type of fuse.
Connections
Before connecting the box to other units, turn off the power for all devices.
Before turning the power on or off for all devices, set all volume levels to
minimum.
Use only speaker cables to connect the speakers to the speaker jacks.
Be sure to observe the amplifiers rated load impedance, particularly when
connecting speakers in parallel. Connecting an impedance load outside the
amplifier’s rated range can damage the amplifier.
Cleaning
The product should be cleaned only with a polishing cloth or a soft dry cloth.
Never clean with furniture wax, benzene, insecticides or other volatile liquids
since they may corrode the cabinet.
Replacement parts
When replacement parts are required, be sure the service technician uses
replacement parts specified by the manufacturer or having the same
specifications as the original part. Unauthorized substitutes may result in fire,
electric shock or other hazards.
Do not open the housing. It doesn’t contain any user serviceable parts.
Please refer servicing to a qualified technician.
Operation
1. Prior to switching the unit on, turn down the volume control to the minimum.
2. Connect the audio source to the appropriate input jack.
3. Another speaker can be connected to the output jack so that two boxes can
be daisy chained.
4. Connect the box to the power supply.
5. Switch on the audio source, followed by the active speaker.
6. Set the volume with the applicable control.
7. Adjust the bass & treble.
1. Mic input level control
9. XLR MIC/LINE input
2. Echo control
10. RCA phono (R+L) line input
3. Treble control for high frequencies
11. RCA Line output
4. Bass control for low frequencies
12. Power LED indicator
5. Line input level control
13.115/230V switch
6. 6.35mm microphone 1 input
14. Speaker out (8 Ohm)
7. 6.35mm microphone 2 input
15. Main power switch
8. MIC/LINE switch
16. Fused IEC mains input
© Copyright Lotronic 2014
© Copyright Lotronic 2014