IBM IntelliStation POWER 285 Quick Start Manual

Summary of IntelliStation POWER 285

  • Page 1

    Quick start guide for intellistation power 285 (9111-285) ibm systems.

  • Page 2: Before You Begin

    Caution: the fully populated enclosure weighs about 95 lbs (43 kg). You should have at least three people available to lift and install the system unit. The exclamation mark surrounded by a gray triangle denotes caution. A caution notice indicates the presence of a hazard that has the potential of c...

  • Page 3: Inventory

    Inventory complete an inventory of the external parts. Locate the kitting report (inventory list) in the bag that contains the information center cd (sk3t-8159). Make sure you received all of the parts that you ordered. Your order information should be located in an envelope adhered to the outside o...

  • Page 4: 3.1

    3.1 3.2 3.3 route the power cords through the rings or clamps, if available, on the back of the workstation, and connect to the system unit, monitor, and hmc. Connect the mouse and keyboard cables to the appropriate ports on the back of the hmc. If your mouse and keyboard use universal serial bus (u...

  • Page 5: 3.5

    3.5 3.6 if you are not using a modem, skip to step 3.6. If you are using the integrated hmc modem, connect the telephone cable to the modem and to the analog jack on the wall. If you are using an external modem, connect the modem data cable to the external modem and to a serial port on the hmc. Then...

  • Page 6: 4.1

    4.1 4.2 caution: this product is equipped with a three-wire power cable and plug for the user's safety. Use this power cable with a properly grounded electrical outlet to avoid electrical shock. The asmi is an interface to the service processor that is required in order to perform general and admini...

  • Page 7: 4.5

    4.5 4.7 4.6 4.4 using a web browser, enter the ip address into the field that corresponds to the port to which your pc is connected. When the login dialog box is displayed, enter either one of the default user ids and passwords: address when you are prompted, change the default password. If you are ...

  • Page 8: Finish Your System Setup

    Finish your system setup 5 using a web browser, go to www.Ibm.Com/server/library/infocenter/hardware or go to the preinstalled version on the hmc. From the navigation bar, click answer the questions in the interactive interview, and follow the procedures in the resulting checklist. Systems hardware ...

  • Page 9

    International business machines corporation 2005, 2007 printed in usa september 2007 all rights reserved mail comments to: ibm corporation attention department ddr 3605 highway 52 north rochester, mn u.S.A. 55901-7829 fax comments to: 1-800-937-3430 (u.S. Or canada) 1-507-253-5192 (outside the u.S. ...