1. DL manuals
  2. IBM
  3. Storage
  4. Slicestor 2448
  5. Appliance Operation Manual

IBM Slicestor 2448 Appliance Operation Manual - Tables

Summary of Slicestor 2448

  • Page 1

    Ibm cloud object storage system ™ version 3.13.1 slicestor 2448 appliance manual 3409-s01/3401-s01/3403-s01 ibm.

  • Page 2

    Note before using this information and the product it supports, read the following information: v the general information in notices v the information in safety and environmental notices v the information in the ibm environmental notices and user guide (provided on a dvd) this edition applies to ibm...

  • Page 3: Contents

    Contents figures . . . . . . . . . . . . . . . V tables . . . . . . . . . . . . . . . Vii document information . . . . . . . . Ix safety and environmental notices . . . Xi safety notices . . . . . . . . . . . . . . Xi environmental notices . . . . . . . . . . Xiv declared noise emissions . . . . . ....

  • Page 4

    Iv ibm cloud object storage system ™ : slicestor 2448 appliance manual 3409-s01/3401-s01/3403-s01.

  • Page 5: Figures

    Figures 1. Rear of appliance with card slot highlighted 3 2. Remove handles from handle carriers . . . . 7 3. Disconnecting the chassis slide assembly . . . 8 4. Install the chassis slide rails to the appliance 8 5. Attach the rack rails to the rack . . . . . . 9 6. Unlock the rails . . . . . . . . ...

  • Page 6

    Vi ibm cloud object storage system ™ : slicestor 2448 appliance manual 3409-s01/3401-s01/3403-s01.

  • Page 7: Tables

    Tables 1. Declared noise emissions in accordance with iso 9296 (1,2,3) . . . . . . . . . . . . Xv 2. Space and power requirements for the appliance. . . . . . . . . . . . . . 3 3. Operating and non-operating temperatures and humidity for the appliance . . . . . . . . 4 4. Cabling requirements for th...

  • Page 8

    Viii ibm cloud object storage system ™ : slicestor 2448 appliance manual 3409-s01/3401-s01/3403-s01.

  • Page 9: Document Information

    Document information intended purpose and audience this manual contains the instructions for installing and maintaining this appliance. The audience for this guide consists of those individuals responsible for installing ibm cloud object storage system ™ appliances. Note: v the equipment and device ...

  • Page 10

    X ibm cloud object storage system ™ : slicestor 2448 appliance manual 3409-s01/3401-s01/3403-s01.

  • Page 11

    Safety and environmental notices review the safety notices, environmental notices, and electronic emission notices for ibm ® cloud object storage system before you install and use the product. Suitability for telecommunication environment - this product is not intended to connect directly or indirec...

  • Page 12

    Xii ibm cloud object storage system ™ : slicestor 2448 appliance manual 3409-s01/3401-s01/3403-s01.

  • Page 13

    Safety and environmental notices xiii.

  • Page 14

    Environmental notices this information contains all of the environmental notices for ibm systems products in english and other languages. The ibm systems environmental notices (http://ibm.Co/1fbgwfi) information includes statements on limitations, product information, product recycling and disposal,...

  • Page 15

    Declared noise emissions table 1. Declared noise emissions in accordance with iso 9296 (1,2,3) product description declared a-weighted sound power level, l wad (b) declared a-weighted sound pressure level, l pam (db) operating idling operating idling model s01 & s02 @ 25 deg. C room ambient 7.7 (4) ...

  • Page 16

    Xvi ibm cloud object storage system ™ : slicestor 2448 appliance manual 3409-s01/3401-s01/3403-s01.

  • Page 17: Support Information

    Support information for more information on the product or help with troubleshooting, contact ibm support at ibmcloudstoragesupport@us.Ibm.Com or visit the directory of worldwide contacts. © copyright ibm corp. 2016, 2018 xvii.

  • Page 18

    Xviii ibm cloud object storage system ™ : slicestor 2448 appliance manual 3409-s01/3401-s01/3403-s01.

  • Page 19

    Chapter 1. Appliance safety precautions observe physical, electrical, and electronic component safety precautions. Physical ensure that your equipment rack is placed in a dust-free, well-ventilated area close to an uninterruptible power supply (ups). Leave enough room behind and around the rack for ...

  • Page 20

    Danger a danger of explosion exists if the onboard battery is installed upside down, which reverses its polarities. This battery must be replaced only with the same or an equivalent type that is recommended by the manufacturer. Dispose of used batteries according to the battery manufacturer’s instru...

  • Page 21

    Chapter 2. Specifications and requirements appliance specifications v single intel xeon e5-2637v3 processor v 8 x 16 gb pc4-17000 2133 mhz ecc registered ram modules v 2 os intel ssdsc2bb120g4 drives v onboard ipmi v 2 onboard 1 gbps network ports. V 1 onboard 1 gbps dedicated ipmi network port. V f...

  • Page 22

    Environmental conditions table 3. Operating and non-operating temperatures and humidity for the appliance environment temperature (°c) temperature (°f) humidity (non-condensing) operating 10–35 50–95 8–90% non-operating -40–70 -40–158 5–95% cabling table 4. Cabling requirements for the appliance cab...

  • Page 23

    Chapter 3. Install the appliance into a rack many racks are on the market, which means that the assembly procedure might differ slightly. This rail fits a rack between 28.5" and 35.5" deep. Prepare for installation assemble tools a #2 phillips screwdriver and a cage nut tool are needed to install an...

  • Page 24

    Table 5. Appliance location considerations (continued) factor comments power supply use a regulating uninterruptible power supply (ups) to protect the appliance from power surges and voltage spikes, and to keep your system operating in a power failure. Heat, electricity, and emi avoid areas where he...

  • Page 25

    V left and right cabinet section assemblies v left and right chassis section assemblies install the handles on the server you must install two handles on each side of the server before lifting it. Caution: make sure that you have adequate support to lift the system. Releasing it before it is fixed i...

  • Page 26

    Disconnect chassis section slide assembly refer to the following figure to open the chassis section slide assembly. Install the chassis slide rails to the appliance 1. With the heads of the locating pins protruding through the set of keyhole openings in the chassis section assembly, pull the slide t...

  • Page 27

    2. Attach the front mounting bracket to the rack rail. 3. Attach the rear mounting bracket to the rack rail. Unlock the rails to insert or remove the chassis 1. With a suitable lift or with four people, align the chassis with the extended rails. 2. Continue to close until the side rails lock. 3. Aft...

  • Page 28

    Cable the appliance 1. On the rear panel, connect the c13 end of the power cables to the c14 inlets in the psus. The power supply power connectors are in the center at the bottom of the rear panel, as shown in the following figure. 2. The ethernet connections are located just to the left of the cent...

  • Page 29

    Chapter 4. Appliance physical interface the physical interface for the appliance consists of buttons and leds on the front panel and ports and leds on the back panel. Front control panel the power status and the hard disk drive and network activity of the appliance can be read from its front control...

  • Page 30

    Table 6. Hdd activity leds (continued) status green red locate off 4-hz flash rebuild flash 1-hz flash 3. Fan failure leds shows red if the fan has an error or is missing (each indicator represents one system fan). If any fan experiences an error or is missing, all system fans are run at full speed ...

  • Page 31

    Rear loading boot drive carrier leds at the bottom of the boot drive carrier, the left led shows power, and is blue when power is on; the right led shows activity, and flashes green when there is activity. 10 gbe nic card leds each sfp connector on the four-port nic card has two leds. The upper led ...

  • Page 32

    14 ibm cloud object storage system ™ : slicestor 2448 appliance manual 3409-s01/3401-s01/3403-s01.

  • Page 33

    Chapter 5. Field replaceable or upgrade units a number of components can be replaced or upgraded in the field. Replacement parts contact ibm support for replacement parts for this appliance. The following customer serviceable parts are available: v power supply module v chassis fan v operating syste...

  • Page 34

    2. At the command prompt, type poweroff. 3. After the appliance is powered off, remove the power cord and network cables from the back of the chassis. 4. Insert finger and thumb into fan assembly holder slots and pull fan assembly out of fan cage. 5. Insert another fan assembly for replacement. 6. K...

  • Page 35

    6. Replace the drive. 7. Insert the new drive tray into the drive bay until it is fully inserted and clicks into place. 8. Plug in the power cable and network cables. 9. Power on the appliance. 10. For drives with no os installed, see install an operating system on a drive. Install an operating syst...

  • Page 36

    Replace a data drive 1. Remove the top front cover and locate the drive by location label or failure led. 2. Press the release tab and pull out the drive tray, as shown in the following figure. 3. Replace the drive in the tray with a new drive. 4. Insert the new drive tray into the chassis until it ...

  • Page 37

    V ! (bottom led) the following figure shows the leds. The leds are driven by internal circuitry and illuminate in an n+1 configuration even without input power. See the following table for the power supply led meanings. Table 7. Power supply led meanings power supply condition power supply leds no a...

  • Page 38

    4. Insert the new power supply fully into the chassis until the green lever snaps into place. 5. Insert the power cord. 6. Verify that all power supply indicators are normal. Install an sfp+ / qsfp optical module 1. Log in to the device as localadmin. 2. At the command prompt, type poweroff. 3. Remo...

  • Page 39

    Caution: handle used batteries carefully. Do not damage the battery in any way; a damaged battery can release hazardous materials into the environment. Do not discard a used battery in the garbage or a public landfill. Refer to the ibm systems environmental notices for battery disposal guidelines. B...

  • Page 40

    22 ibm cloud object storage system ™ : slicestor 2448 appliance manual 3409-s01/3401-s01/3403-s01.

  • Page 41: Notices

    Notices this information was developed for products and services offered in the us. This material might be available from ibm in other languages. However, you may be required to own a copy of the product or product version in that language in order to access it. Ibm may not offer the products, servi...

  • Page 42

    Licensees of this program who wish to have information about it for the purpose of enabling: (i) the exchange of information between independently created programs and other programs (including this one) and (ii) the mutual use of the information which has been exchanged, should contact: ibm directo...

  • Page 43

    Trademarks ibm, the ibm logo, and ibm.Com ® are trademarks or registered trademarks of international business machines corp., registered in many jurisdictions worldwide. Other product and service names might be trademarks of ibm or other companies. A current list of ibm trademarks is available on th...

  • Page 44

    26 ibm cloud object storage system ™ : slicestor 2448 appliance manual 3409-s01/3401-s01/3403-s01.

  • Page 46

    Ibm® printed in usa.