IBM Ultrastar 9ES Quick Installation Manual
Quick installation guide
Ultrastar 9ES
Multimode SE/LVD
1
Models: DDRS-39130 DDRS-34560
Handling precautions
Ÿ
Do not open the electrostatic discharge (ESD) bag
containing the drive until required.
Ÿ
Do not apply pressure on the drive during handling
or installation.
Ÿ
To prevent damage from impact or vibration always
set the drive down gently.
Ÿ
Handle the drive carefully by the edges. Do not
touch the exposed printed circuit board or any
electronic components.
Ÿ
Do not press on the top or bottom of the drive.
Ÿ
Do not cover the breather hole!
Covering the
breather hole may result in loss of data.
Ÿ
Save the packaging materials including the ESD
bag in the event that the drive must be returned.
Installing the drive
This guide provides instructions for the installation of a
multimode SE/LVD hard disk drive.
1.
Backup all data.
2.
Record the serial number and part number of your
hard drive for future reference.
3.
Turn off the computer and remove the computer
system cover.
4.
Before handling the hard disk drive, discharge any
static electricity from you and your clothing. With
one hand touch an unpainted metal surface on your
computer chassis, then touch the ESD bag with the
other hand for a minimum of two seconds. Remove
the ESD bag from the hard drive.
5.
Unplug the computer.
1
PLEASE NOTE: If the Ultrastar multimode SE/LVD
drive is attached to a SCSI bus with SE device(s), the
drive operates in SE mode without installing the forced
SCSI SE mode jumper.
6.
Assign a SCSI address to the drive. Address 7 is
normally reserved for the SCSI controller. Refer to
the illustration below, install the appropriate
jumper(s) on the Option Jumper Block.
SCSI Address
Pin Location
Address 0
Address
2
Address
1
Address
4
Address
3
Address
6
Address
5
Address
7
Address
8
Address
9
Address
10
Address
11
Address
12
Address
15
Address
13
Address
14
Electronic
Component
Side
Option Jumper
Block
7.
Refer to the following illustration to select desired
option(s) and install the appropriate jumpers.
IBM storage products
Page 1
IBM Hard Disk Drive Technical Support Center version 3.0