IBM UPS1000THV Operation And Maintenance Manual - page 64

 60

European Union EMC Directive conformance statement 

This product is in conformity with the protection requirements of EU Council Directive 89/336/EEC on 

the approximation of the laws of the Member States relating to electromagnetic compatibility. IBM can-

not accept responsibility for any failure to satisfy the protection requirements resulting from a non-

recommended modification of the product, including the fitting of non-IBM option cards. 

This product has been tested and found to comply with the limits for Class A Information Technology 

Equipment according to CISPR 22/European Standard EN 55022. The limits for Class A equipment 

were derived for commercial and industrial environments to provide reasonable protection against inter-

ference with licensed communication equipment. 

Attention:    This is a Class A product. In a domestic environment this product may cause radio interfer-

ence in which case the user may be required to take adequate measures.

Taiwan electronic emission statement 

Chinese Class A warning statement 

Statement of Conformity to the Voluntary Control Council for Interference from Informa-

tion 

Power Cords 

For your safety, IBM provides a power cord with a grounded attachment plug to use with this IBM 

product. To avoid electrical shock, always use the power cord and plug with a properly grounded outlet. 

IBM power cords used in the United States and Canada are listed by Underwriter's Laboratories (UL) 

and certified by the Canadian Standards Association (CSA). 

For units intended to be operated at 115 volts: Use a UL-listed and CSA-certified cord set consisting of a 

minimum 18 AWG, Type SVT or SJT, three-conductor cord, a maximum of 6 feet in length and a 

parallel blade, grounding-type attachment plug rated 15 amperes, 125 volts.  

For units intended to be operated at 230 volts (U.S. use): Use a UL-listed and CSA- certified cord set 

consisting of a minimum 18 AWG, Type SVT or SJT, three-conductor cord, a maximum of 6 feet in 

length and a tandem blade, grounding-type attachment plug rated 15 amperes, 250 volts. 

For units intended to be operated at 230 volts (outside the U.S.): Use a cord set with a grounding-type 

attachment plug. The cord set should have the appropriate safety approvals for the country in which the 

equipment will be installed. 

IBM power cords for a specific country or region are usually available only in that country or region.