IBox Beetle User Manual - page 4
FCC statement
This equipment has been tested and found to comply with the limits for a class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular
installation if this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one of the following measures:
ˇ
´
Reorient or relocate the receiving antenna.
ˇ
´
Increase the separation between the equipment and receiver.
ˇ
´
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
To assure continued compliance, any changes or modifications not expressly approved by the
party responsible for compliance could void the user's authority to operate this equipment.
(Example-use only shielded interface cables when connecting to computer or peripheral
devices).
FCC Radiation Exposure Statement
This equipment complies with FCC RF radiation exposure limits sent forth for an uncontrolled
environment. This equipment should be installed and operated with a minimum distance of 20
centimeters between the radiator and your body.
The antennas used for this transmitter must be installed to provide a separation distance of at
least 20cm from all persons and must not be co-located or operation in conjunction with any
other antenna or transmitter.
Channel
The Wireless Channel sets the radio frequency used for communication.
ˇ
´
Access Points use a fixed Channel. You can select the Channel used. This allows you to
choose a Channel which provides the least interference and best performance. In the USA and
Canada, 11 channel are available. If using multiple Access Points, it is better if adjacent Access
Points use different Channels to reduce interference.
ˇ
´
In "infrastructure" mode, Wireless Stations normally scan all Channels, looking for an Access
point. If more than one Access Point can be used, the one with the strongest signal is used.
(This can only happen within an ESS.)
IF using "Ad-hoc" mode (no Access Point), all Wireless stations should be set to use the same
Channel. However, most Wireless stations will still scan all Channels to see if there is an
existing "Ad-hoc" group they can join.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful interference. and
(2) This device must accept any interference received, including interference that may
cause undesired operation.
Rolka
Przełącznik rozdzielczości
Przycisk resetujący kanał kom.
Mysz
Wstęp
Dziękujemy za zakup nowoczesnej optycznej myszy bezprzewodowej. Produkt posiada
nowoczesny wygląd oraz doskonałą czułość zapewniającą komfortową pracę nawet na
drewnianych powierzchniach.
Częstotliwość pracy 2,4 GHz (odległość 6~8 m), 16 kanałów / ID 4096,
Czuła rolka,
Nano-odbiornik,
Długi czas pracy na bateriach,
Automatyczne logowanie do stacji bazowej, PLUG & PLAY,
Włącznik/wyłącznik,
Ergonomiczny kształt
Przełącznik rozdzielczości 800/1600 DPI,
Gumowe separatory do użytkowania na różnych powierzchniach,
2 baterie alkaliczne w zestawie
Produkt zgodny z IEC 60825-1, laser klasy I
Produkt spełnia wymagania stawiane przez FCC oraz CE
Uwaga!
UWAGA!
Nie wolno kierować wiązki w stronę oka !
Zalety:
Pokrywa komory baterii
Odbiornik
Przełącznik stron – przód/tył
Wskaźnik niskiego poziomu
baterii / włączenia myszy
Przycisk zwalniający
odbiornik
Odbiornik
Włącznik/wyłącznik
5
6