IBP WELL TENS Instructions For Use Manual - page 8
32
8. The controls and displays on the Well TENS
Item
Control
Function
1
On/off knob, pulse
strength control
Use the left knob to switch Channel 1 of the Well TENS on
and off.
Use the right knob to switch Channel 2 of the Well TENS on
and off.
You can increase and decrease the strength of the pulses
(0 – 80mA) for Channel 1 and Channel 2 independently
of one another by rotating the appropriate knob clockwise or
anticlockwise.
2
Display
The LED display on the left lights up when you switch on
Channel 1. The LED display on the right lights up when you
switch on Channel 2.
■ Operating mode B: the LED displays flash steadily.
■ Operating modes C and M: the higher the setting of the
pulse rate, the quicker the LED displays flash.
Once the pulse rate reaches approx. 10 Hz the LED displays
remain lit constantly.
3
(µs)
PULSE WIDTH
By turning this dial you can set the pulse width to any level
between 30 μs and 260 μs.
The setting applies to both channels.
4
(Hz)
PULSE Rate
By turning this dial you can set the pulse rate to any level
between 2 Hz and 150 Hz.
The setting applies to both channels.
5
MODE
Use this button to select the mode for your treatment.You can
choose between three modes: continuous mode (C), cyclical
mode (B) or modulated mode (M)
6
TIMER (Min)
Use this sliding switch to set the length of the treatment.
You can choose between three settings:
■
C:
unlimited duration of treatment
■
30:
30-minute treatment
■
60:
60-minute treatment
The setting applies to both channels.
IBP_WellTENS_01_GB_DR.indd 32
01.03.2006 11:08:28