IC Dynamics RS125 Installation Instructions Manual

Summary of RS125

  • Page 1

    Ic dynamics rs125 122706 parts list warning remote start module four button transmitter ten wire harness six wires for power and ignition hook up three wire harness for optional door lock/unlock three wire harness for optional power trunk release/ factory alarm disarm/vacuum switch led service/progr...

  • Page 2

    Before you begin the installation: please read all the installation and operat- ing instructions thoroughly. Familiarize your- self with all the installation steps before you do anything. Refer to the remote start vehi- cle wiring guide. Most, but not all, vehicles are listed in the guide. If your v...

  • Page 3: Remote

    Vehicle battery (+)12 volt power 30 amp fuse + vehicle battery (+)12 volt power 30 amp fuse + service/program switch brown ignition #2 output accessories, heater, air conditioner 12v (+) starter (+) violet orange red red yellow ignition #1 output remote start receiver module ten pin connector brown ...

  • Page 4

    6 3n green wire of 3 pin white connector unlock lock constant ground wiring for 3 wire negative trigger master door lock switch no relays required negative when pushing the unlock button tap into this wire with green wire of 3 pin white connector negative when pushing the lock button tap into this w...

  • Page 5: Ic Dynamics

    Press button 4 for approximately two seconds to activate remote start press button 4 for approximately two seconds again to deactivate remote start. Remote start operation press button 1 for approximately two seconds to lock doors. Optional door lock optional power trunk/hatch release auto cold star...

  • Page 6

    122706 remote start operation start your car from inside your home using the remote transmitters. Ideal for pre-warming your car on cold winter days or cooling it down during the sum- mer. Plus, have the convenience of locking and unlocking your car and release the power trunk/hatch with the remote ...