Summary of AVS-D2110
Page 1
1 megapixel hd avs camera user ’s manual version 1.1.0
Page 2: Table Of Contents
I table of contents 1 general introduction .............................................................................................................. 1 1.1 overview ................................................................................................................... 1 1.2 features ...
Page 3: Welcome
Ii welcome thank you for purchasing our hd avs camera! This user’s manual is designed to be a reference tool for your system. Please read the following safeguard and warnings carefully before you use this series product! Please keep this user’s manual well for future reference!.
Page 4
Iii important safeguards and warnings 1 ．electrical safety all installation and operation here should conform to your local electrical safety codes. The power shall conform to the requirement in the selv (safety extra low voltage) and the limited power source is rated 12v dc in the iec60950-1. We as...
Page 5
Iv please shut down the device and then unplug the power cable before you begin daily maintenance work. Use the dry soft cloth to clean the device. If there is too much dust, please use the water to dilute the mild detergent first and then use it to clean the device. Finally use the dry cloth to cle...
Page 6
1 1general introduction 1.1overview this series megapixel hd camera conforms to the hd avs standard. It supports video signal high-speed long distance transmission without any delay. It can be controlled by the dvr conforming to the hd avs. 1.2features high-performance cmos image sensor, megapixel d...
Page 7
2 model parameter 1 megapixel hd avs camera avs-d2110 video processor 1/3" 1.3 megapixel cmos video format pal/ntsc effective pixel 1280(h)×960(v) min illumination 0.01lux@（f1.2，agc on），0 lux with ir electronic shutter 4/30~1/54,000s video standard hd avs/cvbs compliance video frame rate 1280×720@25...
Page 8
3 2framework please refer to the following figures for the dimension information. The unit is mm. See figure 2-1. Figure 2-1 when the standard definition/high definition switch control cable is short circuit, system outputs standard definition video. Otherwise, when the circuit is open, system outpu...
Page 9
4 3installation important before the installation, please make sure the installation surface can sustain at least 3x weight of the bracket and the camera. Step1 please take the installation position map in the accessories bag, and then paste it on the ceiling or the wall according to your monitor ar...
Page 10
5 do not remove the screw. Loosen a little bit will be ok. Please secure after you completed the setup. Figure 3-2 step 4 line up the bulge of the decoration ring to the nick of the camera body and install along the tilt installation. Push and then turn decoration ring clockwise. The installation co...
Page 11
6 4menu 4.1menu list the 1 st menu the 2 nd menu the 3 rd menu exposu re ae mode global centre centre weight blc front light distingui sh return wb mode awb-gw awb-cct awb-pro awb- temporal awb-ai awb-sz day &night auto b&w color functi on 3d-nr on/off return advanc ed mirror off/horiz ontal/ver tic...
Page 12
7 the 1 st menu the 2 nd menu the 3 rd menu edge auto/manual value 0-15（for manual mode only） return contra st 0-255 satura tion 0-15 bright ness 70-250， +10 return exit save cancel reset 4.2note parameter function 3d nr it is to reduce video noise. The larger the number is, the lower the noise is. ...
Page 13
8 appendix toxic or hazardous materials or elements component name toxic or hazardous materials or elements pb hg cd cr vi pbb pbde circuit board component ○ ○ ○ ○ ○ ○ device construction material ○ ○ ○ ○ ○ ○ wire and cable ○ ○ ○ ○ ○ ○ packing components ○ ○ ○ ○ ○ ○ accessories ○ ○ ○ ○ ○ ○ o: indica...