Summary of K6
Page 1
Hdavs icr ir water proof dome camera user ’s manual version 1.0.0
Page 2: Table Of Contents
I table of contents 1 general introduction .................................................................................................................. 1 1.1 overview ........................................................................................................................ 1 1.2 ...
Page 3: Welcome
Ii welcome thank you for purchasing our hdavs camera! This user ’s manual is designed to be a reference tool for your system. Please read the following safeguard and warnings carefully before you use this series product! Please keep this user ’s manual well for future reference! Important safeguards...
Page 4
Iii it is recommended to use the device with thunder proof device in order to improve thunder proof effect. The grounding holes of the product are recommended to be grounded to further enhance the reliability of the camera. Do not touch the ccd (cmos) optic component directly. You can use the blower...
Page 5
1 1general introduction 1.1overview this series hdavs camera conforms to the hdavs standard. It supports video signal high- speed long distance transmission without any delay. It can be controlled by the havr. 1.2features high-performance cmos image sensor, megapixel definition. support hd video...
Page 6
2 2device framework see figure 2-1 for the dimension. Figure 2-1 see figure 2-2 for the structure components. Figure 2-2.
Page 7
3 3installation dome camera mainly uses ceiling installation; installation surface includes ceiling and wall. Attention: before the installation, please make sure the installation surface is thick enough to sustain at least 3x weight of the camera. for the installation mode of side outlet, make ...
Page 8
4 figure 3-1 step 3 put the dome body vertically into the dome enclosure according to the direction shown in figure 3-2, then cover the compression cover and tighten the screws. Figure 3-2 note: the lens side of the dome body has to be kept vertical; otherwise, the dome body can ’t be inserted into ...
Page 9
5 this step doesn ’t have to be necessary, please install the device according to the actual product. Step 4 adjust the dome pedestal location according to the clients’ requirement of top outlet or side outlet, pull out the cable from the side cable slot between installation surface and pedestal (pl...
Page 10
6 4menu 4.1havr settings this hdavs camera series can adjust osd menu via coaxial control. After connected the camera to the havr, from main menu->setting->system->ptz, you need to select the channel number for access and set control mode as hdavs and the protocol as icr-sd1. Click “save” button to ...
Page 11
7 figure 4-3 see sheet 4-1 for the details of button functions. Button function open menu 、 select menu item 、 select menu value adjust lens zoom and auto trigger focus note: some of the buttons can only be applied for the motorized vari-focal camera. Adjust lens focus auto focus under current zoom ...
Page 12
8 appendix Ⅰ maintenance attention: please maintain the device according to the following instructions in order to ensure the image effect and long-term stable operation of the device. Maintenance for lens and mirror surface the lens and mirror surface are covered with antireflection coating, so it ...
Page 13
9 note this manual is for reference only. Slight difference may be found in the user interface. All the designs and software here are subject to change without prior written notice. All trademarks and registered trademarks mentioned are the properties of their respective owners. If there is any unce...