ICE AIR RSAN Operating & Maintenance Manual - page 8
OPERATING & MAINTENANCE MANUAL –PACKAGED TERMINAL AIR CONDITIONER (PTAC) – RSAN
8
6:08
AM
MON
WAKE
PUSH BUTTONS
Operation
Normal Mode
1. Press [ON/OFF] to turn on thermostat.
2. Press [Mode] to change the system mode.
3. There are three operation modes for Cool Mode,
Heat Mode, Auto Mode.
Cool Mode
•
To activate cooling mode, press the mode
button until COOL displays.
•
Press up/down arrow keys to your desired
temperature.
•
Compressor will cycle when temperature
reaches the set-point. After compressor
stops, allow at least 3 minutes before
restarting (this applies only if you have
manually turned the unit off or reset the
thermostat – during normal running
conditions, the unit will automatically
allow for the required restart delay).
The temperature reading that is on constant
display is the ambient room temperature.
Heat Mode
•
To activate heating mode, press the
Mode button until HEAT displays.
•
Press up/down arrow keys to your
desired temperature.
•
The unit will cycle until the set
temperature is achieved and then will
continuously cycle to maintain the set
temperature.
The temperature reading that is on constant display
is the ambient room temperature.
Auto Mode
•
To activate auto mode, press the mode
button until AUTO displays.
•
Press up/down arrow keys to set
desired heat temperature.
•
Wait 5 seconds for cool to appear.
•
Press up/down arrow keys to set
desired cool temperature.
•
The unit will automatically cycle between heat and
cool modes if unit exceeds desired set points.
The temperature reading that is on constant
display is the ambient room temperature.
Internal Setting
Enter internal setting mode by pressing and holding [Mode]
key for 5 seconds
Time Setting
Set Clock/Day is flashing
1. Press [Mode] key to select Edit “Clock/Day”.
2. Use [Up] and [Down] keys to adjust hours (12 hr).
3. Press [Mode] to select minutes.
4. Use [Up] and [Down] keys to adjust minutes.
5. Press [Mode] to select days.
6. Use [Up] and [Down] keys to adjust days
Press [Fan] when complete.
Daily Programming
Press [On/Off] to select Schedule (Schedule is flashing)
1. Press [Mode] key to select Edit “Set Schedule.”
2. Use [Up] and [Down] to select Day.
3. Press [Mode] to edit time.
4. Use [Up] and [Down] to select Time.
(Adjustable in 10 minute increments)
5. Press [Mode] to edit heat setting.
6. Use [Up] and [Down] to select temperature.
7. Press [Mode] to edit cool setting.
8. Use [Up] and [Down] to select temperature.
9. Press [Mode] to set next time frame.
10. Follow the screen, and repeat steps 2 through 9
to adjust 7 day schedule programming.
11. Press [Fan] when complete.