ICE AIR Vertical Stack Water Source Heat Pump Operating & Maintenance Manual - page 5
OPERATING & MAINTENANCE MANUAL –
VERTICAL STACK WATER SOURCE HEAT PUMP (VWSHP)
5
OPERATING & MAINTENANCE MANUAL –
VERTICAL STACK WATER SOURCE HEAT PUMP (VWSHP)
COOLING MODE
• To activate cooling, press the mode button until COOL displays
• Press up/down arrow keys to your desired temperature
• Compressor will cycle when temperature reaches the set point.
After compressor stops, allow at least 3 minutes before restart-
ing (this applies only if you have manually turned the unit off or
reset the thermostat - during normal running conditions, the unit
will automatically allow for the required restart delay)
The temperature reading that is on constant display is the ambient
room temperature.
HEATING MODE
• To activate heating, press the Mode button until HEAT displays
• Press up/down arrow keys to your desired temperature
• The unit will cycle until the set temperature is achieved and then
will continuously cycle to maintain the set temperature.
The temperature reading that is on constant display is the ambient
room temperature.
LOCKOUT SAFETY
All Ice Air WSHP units have its own lockout circuit to shut down the
compressor during an abnormal condition. During unit operation the
compressor will be automatically turned off due to one of these safety
conditions.
• High pressure
• Low temperature
• Condensate overflow
c) Single Stage Manual Changeover
Programmable 5/2 Day
This thermostat is 5 day/2 day programmable (with
up to 4 set-points per day), single stage (1H/1C),
manual changeover with HEAT-OFF-COOL system
settings and fan ON-AUTO settings. The thermostat
has an LCD display with temperature, set-point(s),
mode, and status indication. The temperature
indication is selectable for ºF or ºC. The thermostat
provides permanent memory of set-point(s) without
batteries. The thermostat provides a convenient
override feature to temporarily change set-point(s).
OPERATING INSTRUCTIONS
OPERATION
IMPORTANT NOTE:
Do not attempt to restart the unit in Cooling mode for at
least three minutes after any of these actions:
•
TurningtheunitOFF
•
ResettingtheTemperatureControltoaWarmer
position
•
SwitchingfromCoolingmodetoanyothermode
A
B
88"
C
D
E
62 12 "
CASING
CHASSIS
WITH FILTER
ACCESS PANEL
WITH HINGED
DOOR
STEEL DOUBLE
DEFLECTION
GRILLE
REVISIONS
REV.
DESCRIPTION
BY
DATE
01
8/19/2013
A
B
C
D
E
VHPW09-15
16
17
18 7/8 18 3/8 41 3/8
VHPW18-24
18
20
20 7/8 21 3/8 45 1/2
VHPW30-36
22
24
24 7/8 25 3/8 45 1/2
6
4
3
2
1
SAB-9237
5
7
8
B
SAB-9237
01
-
-
Third Angle Projection
DATE:
MODEL BY:
365.34
MATERIAL:
08/16/13
VP
ICE-AIR LLC.
80 HARTFORD AVENUE
MOUNT VERNON, NY 10553
PROPRIETARY AND CONFIDENTIAL
WEIGHT (LBS):
FINISH:
N/A
DRAWING BY:
DATE:
TITLE:
SIZE
DWG. NO.
REV
SCALE: NONE
UNLESS OTHERWISE SPECIFIED:
SHEET 1 OF 1
DO NOT SCALE DRAWING
V-WSHP GENERAL ASS'Y (BASIC)
DIMENSIONS ARE IN INCHES
TOLERANCES:
FRACTIONAL 1/32
ANGULAR: MACH BEND 1
TWO PLACE DECIMAL .03
THREE PLACE DECIMAL .015
This drawing is the intellectual property of Ice Air,LLC and
consists of confidential data belonging solely to Ice Air,LLC.
The sharing of this data with you does not constitute a
license to share this data with any third party, which is
strictly prohibited without Ice Air's prior written consent.