Ice King RK132AP Installation And Operating Instructions Manual - page 10
9
4.6. Reversing the Door
The door opening can be reversed from “right hand hinged” to “left hand hinged” if
required. If your appliance is supplied “left hand hinged” simply reverse the
following procedure.
Warning!
When reversing the door, the appliance must not be connected to the mains.
Remove the plug from the mains beforehand.
-
Remove the retaining screws & lift off the Top Cover.
-
Remove the screws and upper hinge assembly then lift the door away
from the lower hinge assembly.
-
Remove the screws, lower hinge and foot assembly. Now remove the
hinge pin from the lower hinge, turn the hinge over and refit the pin into
the same hole.
-
Remove the left foot and refit on the right-hand side.
-
Now fit the lower hinge and foot assembly to the left-hand side. Tighten
the screws.
-
Now place the freezer door onto the lower hinge and then refit the upper
hinge into the pre-drilled holes on the left-hand side of the cabinet.
Tighten the screws.
-
Ensure the door is correctly aligned and sealing correctly. If the door
requires further alignment, slacken off the screws, re-align the door then
tighten the screws.
-
Re-fit the top cover.
Top
Cover
Upper Hinge Assembly
Left Foot
Lower Hinge and Foot Assembly