Ice TRICE X2 Assembly Manual

1

TRICE X2 ASSEMBLY MANUAL 

This is NOT the final manual by any means but might help you figure out what all the 

bits are for. Please refer to the Standard Trice Manual for general things like gear 

adjustment and wheel fitting. 

PLEASE READ THIS BEFORE YOU START: 

Put all the main frame parts together but just nip up the main bolts. 

Put the rear seat on and set the seat angle to roughly what you think looks and feels 

about right. 

Set the rear seat to pedal distance by sitting on and then sliding the rear section in or 

out. (Give the whole section a wriggle up and down with the bolts loose, make sure the 

front seat mount post is loose as well because this has to move up or down at the same 

time). 

Now set the front seat angle about right and the front boom length. 

Once you are fairly happy with these settings, check the machine for alignment (stand 

well back and look down through the length), then tighten up the frame clamping bolts. 

Next, put the chains on and punch them to length. Split the chains at the special power 

link (you will find a couple of them in each chain), punch out the section you don't need 

and join them back together with the power link.  

The front chain tension is adjusted by sliding the clamp on pulley assembly up or down 

the front seat post. It does need to be adjusted reasonably tight with the spring loaded 

arm just there to take up any slack generated whilst pedalling. 

1.  Take all the bits out of the box 

2.  Put the rear handle bars on, parking brake lever goes on the left 

3.  Set the front handle bars upright, note the position of the alloy clamps.