1 installation, operation, maintenance and troubleshooting model 87 be sure unit is standing upright 24 hours prior to plug-in. Table of contents page ice maker safety 2 important safeguards 3 - 4 technical information component locations 5 ice maker installation unpacking 6 location requirements el...
2 safety ice maker safety your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This is the safety alert symbol. This symbol alerts you to potential hazards that can inj...
3 important safeguards before the ice maker is used, it must be properly positioned and installed as described in this manual, so read the manual carefully. The manufacturer strongly recom- mends that you have a professional install your new machine. The warranty may be affected or voided by an inco...
4 • make certain that hoses are not pinched, kinked or damaged during installation. • check for leaks after water line is connected. • although the unit has been tested and cleaned at the factory, due to long-term transit and storage, the first batch of cubes must be discarded. • remove the packing ...
5 service and parts manual 40 402icemaker reduce ice rate, cause water to overflow from ice maker mold, damage the exploded view exploded view of model 87 icer-ette parts list item part # description fig1 1 87201w top and bottom hinge 2 872021 icemaker 115v 872022 icemaker 230v 3 87203w handle latch...
6 installation unpacking remove packaging materials important: do not remove any permanent instruction labels or the data label on your ice maker. Remove tape and glue from your ice maker before using. • to remove any remaining tape or glue, rub the area briskly with your thumb. Tape or glue residue...
7 • unit must sit on a secure level surface. Mounting flange must not be used to support the unit’s weight. It is important for the ice maker to be leveled in order to work properly. If needed, you can adjust the height of the ice maker by revolving the rubber feet. • when mounting unit within cabin...
8 operation 1. Have all packing materials and tape been removed from the interior and exterior of the ice maker? 2. Did you clean the ice storage bin? 3. Have the installation instructions been followed, including connecting the machine to wat- er and electricity? 4. Has the machine been leveled? 5....
9 exterior cleaning the door and cabinet may be cleaned with a mild detergent and warm water solution such as 1 oz.(28g) of dishwashing liquid mixed with 2 gallons()()( of warm water. Do not use solvent-based or abrasive cleaners. Use a soft sponge and rinse with clean water. Wipe with a soft clean ...
10 troubleshooting warning: do not touch the condenser. They are sharp and can be easily damaged. Troubleshooting: before calling for service if the unit appears to be malfunctioning, read through the operation section of this manual first. If the problem persists, check the troubleshooting guide on...
11 specifications: model: 87 electrical power: 115vac ~ 60hz or 230v ac~50hz ice-making /-harvest rated current: 1.8a/1.5a (115v) refrigerant: r134a, 2.47 oz.(70g) high/low side pressure: 380 psig(2.6mpa)/130 psig(0. Mpa) width x depth x height(mm): 14”(356) x 16 1/2”(420) x 24 1/2”(622)** unit weig...
12 raritan engineering company warrants to the original purchaser that this product is free of defects in materials or workmanship for a period of one year from the product’s date of purchase. Should this product prove defective by reason of improper workmanship and/or materials within the warranty ...
