ICES IBT-3 Instruction Manual

Manual is about: Bluetooth tower speaker

Summary of IBT-3

  • Page 1

    Model:ibt-3 bluetooth® tower speaker instruction manual www.Ices-electronics.Com read this instruction manual before operating the appliance.And save it for future reference..

  • Page 2

    Thank you for purchasing tower speaker getting started remove the equipment from the box. Remove packaging and place inside the box to store for future reference and / or use in the box tower speaker unit tower stand and screws to attach the unit 3.5mm aux cable instruction manual remote control fea...

  • Page 3: Safety Instructions

    Safety instructions when using electrical equipments basic safety precautions should always be followed this equipment is not intended for use by persons (including children)with reduced physical, sensory or mental capabilities or lack of experience or knowledge. They should be given appropriate sup...

  • Page 4: Description Of Parts

    Description of parts top panel 1. Standby 2. Mode 3. Mute 4. Led display 5. Volume control 6. Play/pause 7. Skip forward 8. Skip backward front 1. Speaker 2. Remote sensor (point remote to the remote sensor) back panel 1. Usb port output dc 5v 2.1a (for charging only) 2. 3.5mm aux-in jack 3. Sd card...

  • Page 5

    Remote control **point remote at middle of speaker** 1. Standby 2. Mp3 mode button 3. Mute button 4. Aux in button 5. Fm radio button 6. Bluetooth button 7. Skip backward button 8. Play/pause button 9. Skip forward 10. Scan button 11. Ch- 12. Ch+ 13. Bass+ effect button 14. Bass- effect button 15. T...

  • Page 6

    Power setup connect the ac/dc adapter to the dc in socket on the speaker back panel and plug the adaptor into the mains socket. Using the remote control the battery to get your remote control working intially, pull the clear tab from the battery compartment located at the bottom of the remote. If yo...

  • Page 7

    5. If it still doesn't work, please reset the bluetooth and follow above step again. Notes: 1. When the bluetooth icon on the display flashes, means the speaker is searching the previous paired device. 2. Press play/pause button and hold for 10 seconds, the bluetooth icon on the display will flash f...

  • Page 8

    Programming & playing of fm radio presets 1. Follow the steps for playing the fm radio. 2. Press "scan"button on the remote to search and preset stations in memory, (i.E. “p01” – this will blink on the display - and then the preset station frequency number will show on the display). 3. Note: 20 fm s...

  • Page 9

    Trouble shooting before taking the unit to be repaired, please check the following table when a problem occurs. Consult your dealer or service center if the problem cannot be solved with the following information. Problem remedy power system does not turn on or does not respond to the remote control...

  • Page 10

    Specifications note: as a result of continual improvements, the design and specifications of the product within differ slightly from the unit illustrated on the packaging. Service and support for information: http://www.Ices-electronics.Com/ for support: http://icessupport.Zendesk.Com ices helpdesk:...

  • Page 11

    Products with the ce marking comply with the emc directive (2004/108/ec) and the low voltage directive (2006/95/ec) issued by the commission of the european community. Hereby, stl group bv, ankerkade 20 nl 5928 pl venlo, declares that this product is in compliance with the essential requirements and...