Iclebo YCR-M05-02 User Manual - ●
8
1. After flipping over the vacuum cleaning robot,
verify the positions of the left and right side brushes.
2. Match L side brush to L marked part in the direction
of the groove, and push in hard.
3. Match R side brush to R marked part in the direction
of the groove, and push in hard.
1. The protection films on UV generation part of the charger
and display window of the cleaning robot shall be removed
for use without problem of performance.
1
2
Mop plate
There is no battery inside the remote controller at the time of purchase.
Assemble 2 AAA type batteries before using it.
1. Push the cover of the backside of the remote controller downward to open.
2. Check (+)(-) of the battery and assemble.
3. Match the cover to the groove, and close until “click” sounds.
1. Flip over the vacuum cleaning robot, and install the mop plate by combining it to the fixing part of the main body.
2. Wet the microfiber mop with water, squeeze until no water flow, and attach it to the mop plate.
(If water mop mode is not used, separate and keep the mop plate from the main body.)
Ultra microfiber mop
●
Installing the r
obot c
leaner
Check list before using
Assemble side-brush
Remove protection film
Insert remote control battery
Assemble ultra microfiber mop