Icom BC-121N Instruction Manual - page 4
1
DESKTOP CHARGER ADAPTERS
1
Install six appropriate desktop charger adapters into the
spaces of the BC-121N. Several adapters are available as
described in the table at right to accommodate various Icom
portable transceivers.
ï
ï
For the PCB types
Connect the plugs of an appropriate desktop charger adapter
and the BC-121N, then installed the adapter with the screws
(supplied with the adapter)
.
ï
ï
For types requiring the AD-75/AD-88
Install the optional AD-75 or AD-88 to the BC-121N with 4
screws
(supplied with the AD-75/AD-88)
, then attach a desktop
desktop charger adapter to the BC-121N. See the trans-
ceiver’s instruction manual for an approved desktop p charger
adapter.
☞
CAUTION
About the 3-pin connector:
When you replace the desktop charger
adapter from the Li-Ion compatible type to
non-compatible type, fix the 3-pin con-
necter to the bottom of the charger with
adhesive tape, etc., to prevent catching
or touching the 3-pin connector’s termi-
nals with the adapter’s leads, etc.
MUL
TI-C
HAR
GER
Screws supplied with
the charger adapter
Desktop
charger adapter
See NOTE below
Not used
OR
AN
GE
:
CH
AR
GE
GR
EE
N:
FU
LL
NOTE:
Some of the PCB type desktop charger adapters
do not need connection of the 3-pin connector.
The connection is required only for the installing adapter
that is compatible with charging a Li-Ion battery pack.
• Installing the PCB type adapter
• Installing the AD-75/AD-88
• Installing the non-PCB
type adapter
M
BC-121N_ENG2 02.3.5 11:01 AM Page 1 (1,1)