Icom C RP1520 Instruction Manual - page 5
CONTROL FUNCTIONS
REAR PANEL
ANTE
NNA
Outputs the transmitter output power.
Connect to a duplexer with a 50 coaxial cable.
@CONTROL SIGNAL INPUT JACK
[CONTROL INPUT]
Inputs the DTMF remote-control signal.
The repeater is designed for remote control of
received DTMF signals when this jack is out of use.
@ACCESSORY SOCKET [ACC]
Input and output connections for external equip.
ment.
@DC POWER RESET SWITCH [DC RESET]
Activates the DC power operation.
The switch is also used for canceling the exceeding
discharge limiter.
@AC POWER SOCKET [AC]
the supplied AC power cable to a domestic
AC outlet.
A
NTE
NN
A
[
RX ANT
]
Inputs incoming signals from the antenna sent
through the duplexer.
Connect to a duplexer with a 50 coaxial cable.
WARNING: Ground the repeater through this ter-
minal to prevent electrical shocks,
TVI, BCI and other problems.
See p. 4 for more information.
@AC FUSE HOLDER [AC FUSE]
Holds the 3A fuse for the internal AC power supply
DC POWER INPUT TERMINALS
[BACKUP BATTERY]
Connects a 12 V storage battery for the repeater
backup when the AC power is interrupted. These
terminals are also used for DC power operation.
DC FUSE HOLDER [DC FUSE]
Holds the
fuse for the internal DC power supply.