Icom IC-746PRO Service Manual - page 2
INTRODUCTION
This service manual describes the latest service information
for the IC-746PRO HF/VHF TRANSCEIVER.
DANGER
NEVER connect the transceiver to an AC outlet or to a DC
power supply that uses more than 16 V. This will ruin the
transceiver.
DO NOT expose the transceiver to rain, snow or any liquids.
DO NOT reverse the polarities of the power supply when
connecting the transceiver.
DO NOT apply an RF signal of more than 20 dBm (100 mW)
to the antenna connector. This could damage the transceiv-
er’s front end.
ORDERING PARTS
Be sure to include the following four points when ordering
replacement parts:
1. 10-digit order numbers
2. Component part number and name
3. Equipment model name and unit name
4. Quantity required
1110003870 S.IC
NJM2058M-T1
IC-746PRO MAIN UNIT
5 pieces
8810005770 Screw BiH M3
×
8 ZK
IC-746PRO Top cover
10 pieces
Addresses are provided on the inside back cover for your
convenience.
REPAIR NOTES
1. Make sure a problem is internal before disassembling the
transceiver.
2.
DO NOT
open the transceiver until the transceiver is
disconnected from its power source.
3.
DO NOT
force any of the variable components. Turn
them slowly and smoothly.
4.
DO NOT
short any circuits or electronic parts. An insu-
lated tuning tool
MUST
be used for all adjustments.
5.
DO NOT
keep power ON for a long time when the trans-
ceiver is defective.
6.
DO NOT
transmit power into a signal generator or a
sweep generator.
7.
ALWAYS
connect a 50 dB to 60 dB attenuator between
the transceiver and a deviation meter or spectrum ana-
lyzer when using such test equipment.
8.
READ
the instructions of test equipment thoroughly
before connecting equipment to the transceiver.
To upgrade quality, any electrical or mechanical parts and
internal circuits are subject to change without notice or
obligation.