Icom IC-A14 Instruction Manual - page 8
3
1
PANEL DESCRIPTION
D
KEYPAD
(Available with IC-A14 only)
➥
Inputs digit “1” for frequency input or memory chan-
nel selection. (pp. 8, 12)
➥
Inputs “1,” “Q,” or “Z” when programming memory
names. (p. 15)
After pushing
➥
[FUNC]
, turns the ANL (Automatic
Noise Limiter) function ON or OFF. (p. 22)
➥
Inputs digit “2” for frequency input or memory chan-
nel selection. (pp. 8, 12)
➥
Inputs “2,” “A,” “B,” or “C” when programming
memory names. (p. 15)
After pushing
➥
[FUNC]
, starts the scan. (pp. 18,
19)
➥
Inputs digit “3” for frequency input or memory chan-
nel selection. (pp. 8, 12)
Inputs “3,” “D,” “E,” or “F” when programming
➥
memory names. (p. 15)
After pushing
➥
[FUNC]
, selects memory bank
mode, during memory mode. (p. 12)
➥
Inputs digit “4” for frequency input or memory chan-
nel selection. (pp. 8, 12)
➥
Inputs “4,” “G,” “H,” or “I” when programming mem-
ory names. (p. 15)
After pushing
➥
[FUNC]
, turns the weather alert
function ON or OFF. (p. 23)
➥
Inputs digit “5” for frequency input or memory chan-
nel selection. (pp. 8, 12)
➥
Inputs “5,” “J,” “K,” or “L” when programming mem-
ory names. (p. 15)
After pushing
➥
[FUNC]
, enters duplex transmit fre-
quency programming condition, during NAVI band
operation. (p. 24)
➥
Inputs digit “6” for frequency input or memory chan-
nel selection. (pp. 8, 12)
➥
Inputs “6,” “M,” “N,” or “O” when programming
memory names. (p. 15)
After pushing
➥
[FUNC]
, selects duplex operation
during NAVI band operation. (p. 24)
➥
Inputs digit “7” for frequency input or memory chan-
nel selection. (pp. 8, 12)
➥
Inputs “7,” “P,” “R,” or “S” when programming
memory names. (p. 15)
After pushing
➥
[FUNC]
, selects weather channel
mode. (p. 23)
➥
Inputs digit “8” for frequency input or memory chan-
nel selection. (pp. 8, 12)
➥
Inputs “8,” “T,” “U,” or “V” when programming mem-
ory names. (p. 15)
After pushing
➥
[FUNC]
, key touch beep output ON
or OFF. (p. 22)