Icom IC-F110S Instruction Manual - ■Optional Ut-109 /ut-110
12
3
CONNECTION AND MAINTENANCE
■Optional UT-109 /UT-110
installation
q Turn the power OFF, then disconnect the DC power cable.
w Unscrew the 4 screws, then remove the bottom cover.
e Cut the pattern on the PCB at the TX mic circuit (MIC) and
RX AF circuit (DISC) as shown below.
r Install the scrambler unit as described in optional UT-108
installation in the page at left.
t Return the bottom cover and screws to the original posi-
tion.
NOTE: Be sure to re-solder the
above disconnected points when
you remove the scrambler units.
Otherwise no TX modulation or
AF output is available.
MIC
DISC
Front panel
q Dimmer cont. IN or
IGSW cont. IN
w AF OUT
e Det. AF OUT
r Mod. IN
t PTT control IN or
y Horn drive cont. OUT
u AF GND
i Det. AF GND
o Mod. GND
OPTIONAL CABLE PIN ASSIGNMENT
t r e w q
o i u y
FTSW control IN
OPC-617
Cut off the bushing as in the illustra-
tion, when you install the optional
OPC-617.
■ Optional OPC-617 installation
Install the OPC-617 as shown below.
IC-F110_210S_GEN-1.qxd 05.9.16 9:46 AM Page 12 (1,1)