Icom IC-FR3000 Installation Instructions

Summary of IC-FR3000

  • Page 1

    Precaution warning high voltage! Never attach an antenna or internal antenna connector during transmission. This may result in an electrical shock or burn. Warning high voltage! Never install the antenna at any place that person touch the antenna easily during transmission. This may result in an ele...

  • Page 2

    1. Remove top and bottom covers of the repeater. 2. Remove cover for rx unit (located in top compartment of repeater). Antenna relay installation for fr3000/fr4000 repeater tx unit rx unit rx unit rx ant j1 3. Remove rx antenna cable (w12) from j-1 on the rx unit circuit board. 4. Completely remove ...

  • Page 3

    8. Insert the “accessory cable” through the plastic cap and solder the wire end of the cable (+12v=red; t/r=orange; gnd=black) to the relay. Connect this cable to the accessory connector at the back of the repeater. 9. Disconnect internal coax n-male connector from the inside of the tx bulkhead n-fe...

  • Page 4

    6947 count on us!.