Icom iC- r8500 Instruction Manual - page 6
@1
MEMORY SET SWITCH [M-SET] (p. 19)
Used to ‘copy and paste’ the displayed frequency
into another memory channel.
• The first push is used to copy (
appears), and the sec-
ond push is used to paste (
disappears).
• Frequency, mode, tuning step, memory name, etc. can
be programmed into a temporary memory.
@2
MEMORY CLEAR SWITCH [M-CL] (p. 19)
Push and hold to clear the contents of the displayed
memory.
• Bank names cannot be cleared.
@3
MEMORY WRITE SWITCH [MW] (p. 19)
Push and hold to store the displayed frequency,
mode, tuning step, etc. into the selected memory
channel.
@4
BANK SWITCH [BANK] (p.17)
➥
Push momentarily to toggle the bank limit func-
tion ON and OFF (p 18).
• While “BANK” appears, only memory channels within
the selected bank can be selected via the [M-CH] se-
lector.
➥
Push for 1 sec. to increase/decrease the number of
memory channels in the selected bank (p. 21).
@5
MEMORY CHANNEL SELECTOR [M-CH] (p.18)
➥
Selects a memory channel in normal use.
• Clockwise rotation selects higher memory channel
numbers; counterclockwise rotation selects lower
memory channel numbers.
➥
Selects a set mode item when quick set mode or
initial set mode is selected (p. 30).
@6
DELAY/SPEED CONTROL [DELAY/SPEED] (p.28)
Adjusts the scan delay time or scan speed depend-
ing on the [DLY
] switch setting.
• When scan delay time is assigned, this control adjusts
the scan delay time (scan pausing interval) during signal
reception. This setting is effective when “
” is
selected for the scan resume condition.
• When scan speed is assigned, this control adjusts the
scan speed. In this case, scan delay time is determined
while setting.
@7
SCAN SWITCHES [SCAN
]
All of these switches are related to the scan function
in some way as follows:
[MEMO] (p. 23)
➥
Push momentarily to start/stop memory scan.
➥
Push numeral keys, then this key to start memo-
ry scan in the specified bank.
➥
Push this key, then a mode switch to activate
mode select scan function.
➥
Push for 1 sec. to set automatic bank and skip
functions.
• The bank limit function and/or memory skip functions
are activated automatically when “AUTO” is selected
and scan is started.
[SEL] (p. 23)
➥
Push momentarily to start/stop memory select
scan.
➥
Push for 1 sec. to set the memory channel as a
select channel.
[PROG] (p. 24)
➥
Push momentarily to start/stop programmed scan.
➥
Push numeral keys, before or after pushing this
key to start programmed scan using the specified
scan edge group.
• 10 scan edge groups are available.
➥
Push for 1 sec. to program scan edges for pro-
SCAN SET
D/S
M
M
3
1
PANEL DESCRIPTION
MODE
WFM
NB/AFC
AGC
10dB
20dB
FM
AM
APF
TS
TS
SPCH
SSB/CW
AF GAIN
SQUELCH
PHONES
REC OUT
SLEEP/
REC
REMOTE
IF SHIFT
APC
SET
LOCK
COMMUNICATION RECEIVER
iC- r8500
POWER
SIGNAL
S
1 3 5 7 9 +20dB +60dB
FM
RECV
BANK
10-ATT-20
APF-N
AGC-F
AFC
NB
SLEEP
LOCK
ICOM