Icom ID-800H Operating Manual - Basic Operation
Icom ID
–800H Mini–Operating Guide by W5JCK, September 2007
Page 3 of 6
Basic Operation
Turning the power On or Off
Press and hold
[
PWR
]
for 1 sec. to turn the power On or Off.
Selecting a Frequency Band
1. Press
[
BAND●MODE
]
.
2. Rotate the Dial to select the band.
3. Press
[
BAND●MODE
]
to activate the desired band.
You can select between 2m and 70cm bands for transmission,
and 127 MHz, 2m, 220 MHz, 350 MHz, 70cm, 500 MHz, and
900 MHz bands for reception.
Alternatively:
See “Using the HM-133
Microphone” section for instructions on
using the microphone to select a band.
Activating VFO Mode
Press
[
V/MHz●SCAN
]
to activate the VFO mode.
Alternatively: Press the HM-133 microphone
button
[
VFO/LOCK
]
to activate VFO mode.
Operating in VFO Mode
● If necessary, press
[
V/MHz●SCAN
]
to activate the VFO mode.
● To change the frequency using 1 KHz steps, rotate the Dial.
● To change the frequency using 100 KHz, 1 MHz, or 10 MHz steps:
1. Press
[
V/MHz●SCAN
]
one or more times to toggle between 100
KHz, 1 MHz, and 10 MHz tuning steps.
2. Rotate
[
DIAL
]
to change the frequency.
● To start a scan, press and hold
[
V/MHz●SCAN
]
for 1 second.
● To stop a scan, press
[
V/MHz●SCAN
]
.
Note: The digit associated with
each tuning step (100 KHz, 1
MHz, or 10 MHz) disappears
when that step is selected.
Activating Memory Mode
Press
[
M/CALL●PRIO
]
to activate Memory mode.
The
indicator icon appears on the LCD display
when Memory mode is activated.
Alternatively: Press the HM-133 microphone
button
[
MR/CALL
]
to activate Memory mode.