Icom IP100FS Instructions
System requirements
■
(As of January 2015)
PC
D
CPU Clock ........... Intel
®
Core™2 Duo Processor
E6600/2.40 GHz, equivalent or
faster
System memory .. 2 GB or more
Monitor ................ Full HD (1920 x 1080) recom-
mended
At least XGA (1024 x 768)
Sound card .......... For sounding alarms
Speaker ............... For sounding alarms
LAN ..................... 100BASE-TX or faster
Other:
USB 1.1 or 2.0
Hard disk ............. At least 1 GB of free space.
NOTE:
DO NOT
install more than 2 LAN cards in the PC.
Operating System
D
Microsoft
®
Windows
®
8.1
Microsoft
®
Windows
®
8
Microsoft
®
Windows
®
7 (SP1 or later)
Microsoft
®
Windows Vista
®
(SP2 or later)
• The IP100FS can be used with both 32 and 64 bit ver-
sions of the operating systems listed above.
• Except for “RT” versions of Microsoft
®
Windows
®
8.1 or
Microsoft
®
Windows
®
8.
USB flash drive and its files
■
The USB drive contains the IP100FS and its installer.
• “REMOVABLE” and “CD Drive ICOM” windows appear
when the USB flash drive is attached to the PC.
DO NOT
restart or shutdown the PC with the USB
flash drive attached to it. This may be the cause of
data loss and malfunctions.
ALWAYS
remove the
flash drive from the PC before restarting or shutting
down the PC.
PC Standby mode
■
Depending on the PC, the software may not operate
properly after returning from the standby mode. If this
occurs, turn OFF your PC’s standby mode.
Options
■
*1 When using with the IP100FS, the MONITOR switch is
disabled.
*2 CT-23 is necessary when you connect the SM-26 and
the PC.
Note on the CT-23:
•
The CT-23 audio communication contains a high
pitched tone that most people cannot hear. Howev-
er, if you do hear it, lower the PC’s audio volume.
•
If the booster, amplifier or filtering function is set
in the microphone interface of the PC, deactivate
them.
•
If the microphone’s PTT malfunction occurs, adjust
the microphone recording level properly.
About the firewall setting
■
The IP100FS communication may be blocked by your
firewall.
In that case, a protocol and port numbers listed below
should be allowed to pass the firewall.
See your firewall instructions for the correct settings.
Protocol
: UDP
Port number
:
Source Port Number*
→
Server Port Number*
Source Port Number*
←
Server Port Number*
Source Port Number*
←
Dynamic port
* Refer to the port numbers set in the site settings of
the IP100FS.
(
→
Menu Bar > Option > Setting... )
R
WARNING! NEVER
disassemble, modify or repair
the IP100FS USB flash drive. This may result in an
electrical shock, cause a fire or damage the drive.
R
WARNING! NEVER
operate or touch the IP100FS
USB flash drive with wet hands. This may result in an
electrical shock or damage the drive.
CAUTION: DO NOT
place the IP100FS USB flash
drive in direct sunlight. This could damage the IP100FS
drive.
CAUTION:
DO NOT
use harsh solvents such as ben-
zine or alcohol to clean the IP100FS USB flash drive,
as they can damage the drive’s surfaces. If the USB
flash drive becomes dusty or dirty, wipe it clean with a
dry, soft cloth.
Always place the IP100FS USB flash drive in a secure
place to avoid inadvertent use by children.
PRECAUTIONS
INSTRUCTIONS
The IP100FS
ip
advanced
radio
system
remote
com
-
municator
allows you to remotely communicate with
WLAN transceivers connected to your IP1000C from
a PC through IP networks.
IMPORTANT
READ ALL INSTRUCTIONS
carefully
and completely
before using the IP100FS.
SAVE THESE INSTRUCTIONS
—
These instructions
contain important safety and operating instructions for
the IP100FS.
EXPLICIT DEFINITIONS
WORD
DEFINITION
R
WARNING!
Personal injury, fire hazard or electric
shock may occur.
CAUTION
Equipment damage may occur.
NOTE
If disregarded, inconvenience only. No risk
of personal injury, fire or electric shock.
IP ADVANCED RADIO SYSTEM
REMOTE COMMUNICATOR
OPERATION NOTE
• Ensure that your PC supports USB port(s) operation by
confirming the Universal Serial Bus controller is in the PC’s
Device Manager.
• We recommend that you insert the IP100FS USB flash
drive to the PC’s USB port. Connecting it through a hub
may damage the drive or make it work improperly.
• When operating the PC or external devices, see their in-
struction manuals for operational details.
INSTALLATION NOTE
FCC INFORMATION
CAUTION:
Any changes or modifications not expressly ap-
proved by Icom Inc., could void your authority to operate the
equipment under FCC regulations.
FOR CLASS B UNINTENTIONAL RADIATORS:
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reason-
able protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in ac-
cordance with the instructions, may cause harmful interfer-
ence to radio communications. However, there is no guaran-
tee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and re-
ceiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician
for help.
1. BEFORE STARTING THE IP100FS
Follow the instructions and install the IP100FS dispatching software. The IP100FS USB flash drive must
also be inserted into the PC every time you start up the IP100FS dispatching software.
• To operate the software, refer to the IP100FS Help file.
• Purchase a speaker, headset or a microphone (See options below) to meet your needs.
The displayed dialogue boxes, indications or opera-
tions may differ slightly, depending on your system
settings, type of OS and its service pack* level.
* In this leaflet, service pack is written as SP from further
on.
IP100FS
About the IP100FS Help file:
Please refer to the Help file of the software for assistance
with the functions or settings.
To open the Help file, click “Help” in the Menu Bar of the
software and select “Help,” or simply push the [
F1
] key on
the PC’s keyboard.
USB flash drive
HM-152
hand
microphone
SM-26*
1
desktop
microphone
CT-23*
2
ptt
microphone
adapter