Icom MXG-5000S Instructions

– 4 –

– 1 –

INSTRUCTIONS

GPS RECEIVER

MXG-5000S

Thank you for choosing this Icom product.

READ ALL INSTRUCTIONS

 carefully 

and completely before using this product.

PRECAUTIONS

This equipment has been tested and 

found to comply with the limits for a Class 

A digital device, pursuant to part 15 of the 

FCC Rules. These limits are designed 

to provide reasonable protection against 

harmful interference when the equipment is 

operated in a commercial environment. This 

equipment generates, uses, and can radiate 

radio frequency energy and, if not installed 

and used in accordance with the instruction 

manual, may cause harmful interference 

to radio communications. Operation of this 

equipment in a residential area is likely to 

cause harmful interference in which case 

the user will be required to correct the 

interference at his own expense.

CAUTION: NEVER

 immerse the GPS 

receiver in water. The GPS receiver meets 

IPX6 requirements for high-pressure water 

jet resistance. However, once it has been 

dropped, high-pressure water jet resistance 

cannot be guaranteed because of possible 

damage to its case or the waterproof seal.

DO NOT

 use or place the GPS receiver in 

areas with temperatures below –20°C (–4°F)

or above +60°C (+140°F).

DO NOT

 use harsh solvents such as Benzine 

or alcohol to clean the GPS receiver, as they 

will damage the receiver’s surfaces.

The GPS receiver is only for the specified 

Icom equipment such as MarineCommander™ 

or MA-500TR! — Other manufacturer’s 

equipment may have different pin 

assignments and can damage the equipment 

or GPS receiver if attached.

Item Quantity

q

 Hose clamp (HAS-40) ..............................2

w

 Extension pipe (2273 pipe) ......................1

FCC INFORMATION

CAUTION: 

Changes or modifications to 

this device, not expressly approved by 

Icom Inc., could void your authority to 

operate this device under FCC regulations.

Hereby, Icom Inc. declares that 

the versions of MXG-5000S 

which have the “CE” symbol on 

the product, comply with the 

essential requirements of the Radio Equipment 

Directive, 2014/53/EU, and the restriction of the 

use of certain hazardous substances in 

electrical and electronic equipment Directive, 

2011/65/EU. The full text of the EU declaration 

of conformity is available at the following 

internet address:

http://www.icom.co.jp/world/support/

This device complies with Part 15 of the 

FCC Rules. Operation is subject to the 

following two conditions: (1) this device 

may not cause harmful interference, and 

(2) this device must accept any interference 

received, including interference that may 

cause undesired operation.

SUPPLIED ACCESSORIES

 • Power source voltage:  4.75 to 5.25 V DC

  (supplied from the connected equipment)

 • Operating temp. range:  −20˚C to +60˚C,

  −4˚F to +140˚F

 • Relative humidity:  

   Less than 95% 

(at +35˚C, +95˚F)

 • Dimensions: 

       78(d) 

× 

96.5(H) mm,

       3.1(d) 

× 

3.8(H) inch

 • Weight (approximate):  460 g, 1 lb

 • Cable length (approximate): 10 m, 32.8 ft.

 • Receive frequency:  1575.42 MHz

 • Receive channels:  66 channels

 • Receive codes:    

L1, C/A-code, SPS

 • Satellite differential type:

WAAS, EGNOS, MSAS, 

GAGAN

 • TTFF (Time to First Fix):

     40 seconds (typical)

SPECIFICATIONS

All stated specifications are subject to change without notice or obligation.

q

w

ABOUT CE AND DOC

WORD

DEFINITION

CAUTION

Equipment damage may 

occur.

NOTE

Recommended for optimum 

use. No risk of personal injury, 

fire or electric shock.

EXPLICIT DEFINITIONS

1-1-32 Kamiminami, Hirano-ku, Osaka 547-0003, Japan.

A7149H-1EX-3    Printed in Japan

© 2014–2018 Icom Inc.

DISPOSAL

The crossed-out wheeled-bin 

symbol on your product, 

literature, or packaging 

reminds you that in the 

European Union, all electrical 

and electronic products, 

batteries, and accumulators 

(rechargeable batteries) must be taken to 

designated collection locations at the end of 

their working life. Do not dispose of these 

products as unsorted municipal waste. 

Dispose of them according to the laws in your 

area.

Icom is not responsible for the destruction, 

or damage to, or performance of any Icom 

or non-Icom equipment, if the malfunction 

is because of:

•  Force majeure, including, but not 

limited to, fires, earthquakes, storms, 

floods, lightning, other natural disasters, 

disturbances, riots, war, or radioactive 

contamination.

•  The use of Icom products with any 

equipment that is not manufactured or 

approved by Icom.

Icom, Icom Inc. and the Icom logo are registered 

trademarks of Icom Incorporated (Japan) in Japan, 

the United States, United Kingdom, Germany, France, 

Spain, Russia, Australia, New Zealand, and/or other 

countries.

MarineCommander is a trademark of Icom 

Incorporated.