1. DL manuals
  2. ICON Health & Fitness
  3. Treadmill
  4. WESLO CADENCE S5
  5. User Manual

ICON Health & Fitness WESLO CADENCE S5 User Manual

Summary of WESLO CADENCE S5

  • Page 1

    Part no. 237158 r0306a printed in china © 2006 icon ip, inc. User's manual serial number decal model no. Wetl13906.0 serial no. Caution read all precautions and instruc- tions in this manual before using this equipment. Save this manual for future reference. Ordering replacement parts to order repla...

  • Page 2

    Table of contents important precautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 before you begin . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...

  • Page 3

    18 3 problem: the walking belt slows when walked on solution: a. If an extension cord is needed, use only a 3-conductor, 1mm 2 (14-gauge) cord that is no longer than 1.5 m (5 ft.). B. If the walking belt is overtightened, treadmill perfor- mance may decrease and the walking belt may be- come damaged...

  • Page 4

    4 17 maintenance and troubleshooting most treadmill problems can be solved by following the steps below. Find the symptom that applies, and follow the steps listed. If further assistance is needed, please see the front cover of this manual. Problem: the power does not turn on solution: a. Make sure ...

  • Page 5

    5 how to lower the treadmill for use 1. Hold the upper end of the treadmill with your right hand as shown. Using your left hand, pull the latch knob to the left and hold it. Next, lower the frame until it is past the latch pin. Then, release the latch knob. 2. Hold the frame firmly with both hands, ...

  • Page 6

    6 15 assembly assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials; do not dispose of the packing materials until assembly is completed. Note: the underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a smal...

  • Page 7

    14 7 3. With the help of a second person, raise the uprights (53, 54) so the base (52) is flat on the floor as shown. Next, position the front of the treadmill frame (51) between the uprights. See the inset drawing. Locate the wire inside of the lower end of the right upright (54). Secure the wire t...

  • Page 8

    13 8 6. Hold the console assembly (91) near the right upright (54). Touch the right handrail to discharge any static. Insert the end of the wire harness (98) into the hole in the bottom of the right handrail (55) and out of the large hole in the side. Next, insert the end of the wire harness through...

  • Page 9

    How to use the manual mode insert the key into the console. See how to turn on the power on page 11. Select the manual mode. When the key is in- serted, the manual mode will be selected. If you have selected a speed program, rese- lect the manual mode by pressing the program select button repeatedly...

  • Page 10

    11 10 the pre-lubricated walking belt your treadmill features a walking belt coated with high-performance lubricant. Important: never apply sili- cone spray or other substances to the walking belt or the walking platform. Such substances will deterio- rate the walking belt and cause excessive wear. ...

  • Page 11

    Part list—model no. Wetl13906.0 r0306a star washer (33)–2 handrail washer (11)–2 formed washer (31)–4 wheel nut (38)–2 3 star washer (9)–6 (may be an internal star washer) 3/8” washer (11)–6 3/8” star washer (69)–2 5/16” washer (31)–4 u-nut (105)–4 3 1 1/4” tek screw (58)–4 3” bolt (30)–4 3” bolt (2...

  • Page 12

    80 21 21 103 17 81 100 51 27 101 67 28 105 97 21 83 103 109 54 52 35 70 35 51 65 113 111 53 14 1 9 45 45 29 98 1 111 14 9 63 26 75 3 93 34 38 44 31 79 46 63 26 63 26 26 63 25 21 21 25 25 25 25 29 25 25 106 7 108 34 25 77 77 41 30 74 74 64 41 59 38 104 68 61 60 37 22 28 18 46 19 107 36 36 69 110 32 4...