Intergas HSE–125–N/P User's Information Manual - page 2
HSE User’s Information Manual
2
MAJOR COMPONENTS
A CH
pump
B Gas
valve
C Burner controller with operating panel
D Supply sensor S1
E Return sensor S2
F Blower
G DHW Flow switch
H CH Pressure gauge
I N/A
J
CH manual air vent
K Sight glass and mirror for checking
flame
L Air
supply
M Flue
discharge
N Wiring connecting block / terminal
O Condensate
discharge
P Domestic hot water sensor S3
Q Condensate
trap
R Heat
exchanger
S Operating and display panel
T Ionisation/ignition
probe
U
V
W
Front cover fixing screw
High limit sensor S7 (not shown)
Flue sensor S8 (not shown)
About Our Manuals
Section 1
Your
Super Hot
appliance has been provided with two manuals:
User's Information Manual
- This manual is intended for the
owner or user
of the appliance and provides
information on routine operation and maintenance, and emergency shutdown.
Installation and Service Manual
- This manual must only be used by a
qualified heating installer,
service technician or gas supplier
. Installation or service by anyone unqualified to do so may result in
severe personal injury, death or substantial property damage.
Both manuals should be kept in the envelope provided and affixed adjacent to the appliance so that they
are readily available for future reference. Using these manuals you can safely install and maintain this
appliance.
Refractory Handling
Section 2
WARNING
The mineral block used in this product are RCFs (Refractory Ceramic Fibers).
RCFs pose a possible cancer hazard by inhalation and can cause respiratory,
skin and eye irritation. After mineral block has been fired, it will produce
increased levels of nuisance dust and poses increased carcinogenic risk.
Refractory Ceramic Fibers are contained within the combustion chamber of the heat exchanger. Only a
qualified installer or service technician should attempt to install, service or remove the boiler and must do
so following the precautionary measures described in the
Installation and Service Manual
.