Intergraph 28hd96 Installation Manual

DHAF02800  08/97

28hd96 Monitor Installation

Use this document to install the 28hd96 monitor onto a single or dual Ergo stand.  The monitor kit

includes the following hardware:

u  

Base plate - CFAB078G

u  

Bracket - CFAB079G

u  

Shoulder screws - CFAB934D

u  

Hex bolts - CPHW8790

u  

Lock nuts - CPHM1150

WARNING

To prevent personal injury and damage to equipment, two people must perform the following

precedures.

Remove the Existing Monitor

To remove the existing monitor:

1.  Turn off power to the monitor; then disconnect the power cord from the monitor.

2.  Remove and retain the screws that secure the monitor to the Ergo stand.  The screws are located

underneath the monitor at the back of the stand.

3.  Slide the monitor back and lift it off the stand.  Set the monitor aside.

WARNING

Do not set the monitor on its display screen.  Damage may result.

Install the 28hd96 monitor

See the figures on page 2 and 3 for details.  The circled numbers in the figures match the following

steps.

To install the 28hd96 monitor:

1.  Attach the shoulder screws to the base plate.  Use the four outer holes for a single-monitor

configuration, or the four inner holes for a dual-monitor configuration.

2.  Attach the bracket to the base plate.  The base plate includes four press studs.  Secure the bracket

using the four lock nuts.

3.  Attach the base plate to the monitor using the two hex bolts.

4.  Place the monitor onto the Ergo stand, setting the shoulder screws inside the holes.  Slide the

monitor so the shoulder screws lock in the holes.

5.  Thread the screws (retained from the previous monitor) through the bracket into the mounting

holes of the stand.  Alternately turn each screw about two turns until the monitor is securely

fastened to the Ergo stand.

6.  Connect the video and power cables to the monitor.