Intergraph Intense 3D Pro 3400 Installation Manual - page 16
13
NOTE
The connector of the vertex data bus cable can be installed in only
one orientation.
Finish the Installation
To finish the installation:
1.
Close the computer.
2.
Connect the computer monitor’s video cable to the blue video output port on
the Intense 3D Pro 3410 card. See the following figure.
If a computer monitor has no built-in video cable, use a shielded
video cable with a 15-pin (D-sub) video connector at one end for
the video output port on the card, and the appropriate connectors at
the other end for the video input port on the computer monitor.
NOTE
Monitor input ports are usually D-sub or Bayonet Nut Connect
(BNC) connectors. Shielded cables usually have a ferrite core (a
box- or cylinder-shaped attachment) near each end to reduce
interference with radio frequencies.
3.
Turn on the computer. The video display starts in VGA mode.
4.
There is no need to install the Intense 3D Pro Video device driver if it is
already installed. The system will automatically recognize the Geometry
Accelerator.