Interserve firewall quick-start guide january 1998 dsa077920
Warranties and liabilities the information and the software discussed in this document are subject to change without notice and should not be considered commitments by intergraph computer systems. Intergraph computer systems assumes no responsibility for any errors in this document. The software dis...
Contents introduction ..................................................................................................................................... 1 getting started .................................................................................................................................
1 introduction welcome to the world of internet computing! Intergraph computer systems’ interserve firewall is a server system configured for use as a security device known as a network firewall. Interserve firewall controls external network access to and from your organization’s internal transmissi...
2 getting started to set up and configure your interserve firewall and its firewall-dedicated software: 1. Read this quick-start guide completely to understand what you need to do and when you need to do it. 2. Read “connecting to the internet” in this document and gather the required networking inf...
3 obtain and record the following transmission control protocol/internet protocol (tcp/ip) networking information: u external ip address for your system: u external ip subnet mask for your system: u internal ip address for your system: u internal ip subnet mask for your system: u ip domain name for ...
4 installing and configuring eagle nt after initial configuration of windows nt server is complete, you can install and configure eagle nt. Note before attempting to install eagle nt, you must log on to the system as administrator. Logging on to another user account with administrator privileges wil...
5 troubleshooting the configuration this section contains answers to frequently asked questions and a list of troubleshooting techniques to help you if you have problems with your eagle nt configuration. Refer to the eagle nt configuration guide for more information. Frequently asked questions nothi...
6 why can’t i ping through the firewall? Ping is an internet control message protocol (icmp) message type, not a tcp message type. Icmp message types are not allowed to run through the firewall. A tunnel can be created to pass icmp, but this is not recommended. Tunnel creation is described in the ea...
7 u if you install eagle nt and later make the system a dual-boot system, the system’s volume id will change and the raptor key will then be invalid. U the inside nic gateway address should be blank. U every inbound and outbound connection at the firewall should be logged. U shut down the eagle serv...
8.
