Megaraid controller battery backup module installation guide february 1998 dha026400
Copyright 1998 intergraph computer systems. All rights reserved. This document contains information protected by copyright, trade secret, and trademark law. This document may not, in whole or in part, be reproduced in any form or by any means, or be used to make any derivative work, without written ...
1 megaraid controller battery backup module this document describes how to install a battery backup module on a megaraid controller board. The battery backup module is a card that connects to the top of the megaraid controller board and provides emergency battery power for cache memory. A battery pa...
2 installing the battery backup module you must follow the instruction sequence in this section to avoid damage to the megaraid controller board. Do not connect the battery pack to the battery backup module before attaching the battery backup module to the megaraid controller. Warning personal injur...
3 battery backup module standoff washer j6 large screw washer j5 j19 j21 mounting hole large screw megaraid controller board to connect the metal clip: 1. Place the metal clip flat against the megaraid controller board. Align the threaded hole of the metal clip with the hole of the battery backup mo...
4 to connect the battery pack cable and install the megaraid controller: 1. Attach the battery pack cable connector to j2. See the following figure. Battery pack cable j2 megaraid controller board 2. Install the megaraid controller in the system. 3. Close the system base unit. See the system’s docum...
