Tdz 2000/extremez late-breaking news april 1999 dha024181.
Copyright 1999 intergraph computer systems. All rights reserved. This document contains information protected by copyright, trade secret, and trademark law. This document may not, in whole or in part, be reproduced in any form or by any means, or be used to make any derivative work, without written ...
1 general powering down the system if you use the “power down the computer” option in the automatic shutdown utility, you must press the standby button to turn off system power. Matrox millennium g200 agp graphics if your system was delivered with an installed matrox millennium g200 agp video displa...
2 system bios please note the following items related to the system bios: ♦ the troubleshooting information in the system setup document contains a list of beep codes and associated error messages. You can disregard these codes and messages, as they are not used by the tdz 2000. If your system power...
3 option notes hard disk power down mode this option specifies the power conserving state that the hard disk drive enters after the specified period of hard drive inactivity has expired. The settings are disabled, standby, or suspend. The optimal and fail-safe settings are disabled. Hard disk time o...
4 supply to finish starting the first drives. See the disk drive documentation or the disk drive label for information on activating delayed start. Windows nt 4.0 ethernet network setup and configuration on a system equipped with an ethernet network adapter, note the following: ♦ network adapter dri...
5 8. Exit from the registry editor. 9. Restart the system. Installing the adaptec scsi controller driver if you reinstall windows nt 4.0 on a system with an optional adaptec scsi controller, be sure to reinstall the driver for the scsi controller (2940 scsidrv ) from backup diskette during setup. To...
6 after installing piix 4 w 95, the system restarts several times. During these restarts, windows 95 detects various hardware devices in the system. If you are prompted to load any device drivers, load only the pci standard host cpu bridge and the intel 82371ab pci bus master ide controller. Cancel ...
7 95, you must disable the use of hardware monitor on the system. To do this, run the bios setup program, and set the h/w monitor, primary i/o portparameter in the chipset menu to disabled. See the system setup document for information on running the bios setup program and changing bios settings. Co...
8.
