Interlink Electronics RemotePoint Presenter Start Manual

Start Guide 

Box Contents 

RemotePoint Presenter 

2 AAA Batteries 

USB Receiver 

CD-ROM  

Carrying Case 

Start Guide

RemotePoint Presenter Start Guide 

page 1 

Installing Batteries     

in the RemotePoint 

Presenter Remote 

•  Remove the battery cover on the 

underside of the RemotePoint 

Presenter Remote. 

•  Insert the two AAA batteries in the 

compartment. Ensure that the 

batteries are in the correct orientation 

as indicated by the positive (+) and 

negative (–) markings. 

•  Replace the battery cover. 

Connecting the USB Receiver 

•  Remove the protective cap from the 

USB Receiver. 

•  Flip up the antenna. 

•  Insert the receiver into an available 

USB port on your computer.  

•  The slowly flashing green light 

indicates that the receiver is working. 

Because RemotePoint Presenter uses 

radio waves, the receiver can be placed 

anywhere. You do  not need to place it 

where you have a line-of-sight 

connection with the RemotePoint 

Presenter Remote. 

Note:   Shortly after you connect the receiver, Windows might display the Add New 

Hardware wizard. If required, click Next a few times to get through the wizard. 

Some Windows 98 computers require that you insert your Windows 98 

installation disk.  If you do not have this available, an alternative solution is 

provided on your RemotePoint Presenter CD in a file titled Win98.pdf.